Search results

What is leaking here, and how bad am I screwed?

1. Is there any circumstance or cocktail mix under which it is acceptable to use E85 in a multiifuel vehicle? 2. Can WVO be used without doing something to neutralize the acids in it, and if so is this dependent upon what/how much it is mixed with?

Is there a way to remove the driver's seat back without removing the entire seat? Tried search, one thread addresses it, but he pulled the seat.

I have been Deucified. Here it is. Wish me luck!

The worst thing about the Deuce I am purchasing is the seating position. I'm 6' 5" and somehow I remember a lot more leg room when I drove these in the Service, many moon ago. My knees have to bend to an unusual and surprising angle to operate the clutch and the brake. I spent a few minutes...

Hi, I've got a PE-95 genset with the GPW engine. The head gasket blew. While I have the head off to complete the repair, I was wondering if you can mill the head a bit to increase the compression. I would not mind a slight increase in the CR. While I still want to run regular gas, I...

Hi, I've got a PE-95 genset with the GPW engine. The head gasket blew. While I have the head off to complete the repair, I was wondering if you can mill the head a bit to increase the compression. I would not mind a slight increase in the CR. While I still want to run regular gas, I would...

OK, so sometimes you think you know, but if you are honest with yourself you realize that you might not have it down pat. So please help enlighten me: What are the major differences between an M35, M35A1 and M35A2? Are the differences minor, or some to be avoided? What can you run in a...

Here's a shot of my new trailer. The tires are dated 1964 and I have already made two 600 mile round trips. We used to build some great things in this country.

Here's my new trailer. Given to me by a good friend who decided he no longer needed it. The tires are dated 4/68. :)

In general, are blackout lights supposed to be mounted on the driver's or passenger's side? (Front and rear.)

I have a question as to how you all prep a large MV prior to paint. I've seen plenty of SS threads where, for example, someone is bobbing a deuce with peeling paint on a rusty frame, then cutting and welding, and then poof! it's tomorrow and the deuce is painted, including the frame and running...

It would be nice to have a Forum reference picture album one a front and rear 3/4 view of each model MV.

Hi all, I'm new here, not new to life or machinery or MV, but new to this forum. I figure if you have a question, take it to the folks that should know. I am considering Coker 7.50 x 15 non directional tires for my DD civilian Jeep. But all of my experience with these tires was in the...

Hello all, nice to be here. Looking forward to learning and participating. Not too much to say about myself, I'm no spring chicken, and without a MV at the moment.