Search results

:doh: FOUND IT !!! "Diagnostic Resistor Board" http://www.steelsoldiers.com/cucv/57336-card.html Thanks

If that the GP module, then what is the one below, I've post here? I ordered a GP Module from CUCV Electric for a CUCV M1009 and I got the one below...

OK I've done the wire clean up, and ready for the next step..[thumbzup] New setup works GREAT!!! After changing the ground wire around as you stated, my "wait" light and other dash light are working like they should...:-P

What module is this? Is it the low coolant module?

Fender, Door & Hood Replaced my right front fender and door and hood. Replaced the window regulator in the door, I don't know who designed that door but they should be SHOT!!!! There's got to be an easier way to replace a regulator..aua :rant:

Yesterday, I measured the coil resistance and got 3.4 ohms, then I rechecked the relay with another ohm meter this evening, and it checked 9 ohms.

haven't measure the resistance yet, I'll let you know what I get...

So, doghead you think I'm good to go with the relay I've got?

1stSarge, Thanks for the info, I’m new at the CUCV world, and trying to learn as I go along. I got this relay off of EBay and it suppose to be a military surplus item. I may just go and get a ST85 to be on the safe side.. Thanks, Uncle Sam

Right now... I'm in the middle of trying to remove the right fender auaand BOY!!! what a job it is..... looks like I've got to cut almost all the bolts off...:shock:

Waiting on my GP Module, (should be in anyday) before I do anything more on the wiring, thought I'd do all that at the same time. And I'm hunting some #8 red wire. I'll get back to ya, when I get that done

Thanks for the info, you guys make it a whole lot easier for dummies like me...[thumbzup]

doghead, On teh GP relayy, there is no continuty between either of the 2 small studs, to the mount, but there is continuty between the 2 small studs, is this the way it should be? Also I'm wanting to add a mechanical water temp gauge. The question I have is does the GP Module use the front...

Thanks for the info...brother-in law has a angle grinder I'll just get his, and save a $..:D

Now if I'd had a plasma cutter, [thumbzup]I would have done the same...:beer:

Yank-Her-Off YEA!!!!!!!:jumpin: I got the bumper & brush guard off today, almost all the bumper bolts just turned in the bumperaua like I thought they would... Removing the braces from the frame... IS :hammer: the way to go, it make it a lot easier to remove. 14 bolt to remove. Now I'll...

Thanks I guess I was making it harder than it really is, I've sprayed them with PB Blaster, yesterday. I was planning on replacing the bolts and nuts. I was just hoping there was a easy way, but for a old man like me, there's not a easy way working under one of these....:shock: Thanks for the...

I need help removing front bumper and brush guard. Is there an easy way of removing these. I was hoping to remove them and have them straighten, and to get at the nuts with my impact wrench, but looks like going to a problem.aua Maybe removing the braces from the frame would be the way to...

This is the new GP relay I got to put on, is it the correct one for CUCV?

Thanks doghead, I've the correct relay, that I'm going to change before I replace the GP Module. BTW I ordered a new GP Module from CUCV Eletric, on the 28th of Aug, and have not received it yet, does it always take awhile to get it from them? And thanks warthog, I'd plan on keeping the GP...