Search results

Before pulling the trigger on an unknown unit at an auction I would suggest looking at the cost of new civilian machines. If you are considering buying a MEP1040 you might be surprised that you can buy a NEW civilian unit of the same wattage for similar or even less $$$. It won't have some of...

I thought Portlandia was a pretty funny show till I spent 2 years in Portland working on a project. I then understood it was a documentary. o_O

I'm certainly not buying at those prices. No worries there. I won't denounce capitalism BUT I will have harsh words for faux capitalism. Small markets, closed markets, and monopolistic markets can LOOK like capitalism but not truly be capitalistic due to them not being fair and open with...

Yea, I saw that too. I'll be looking at alternatives but for the first one I coughed up the $150 to get it.

That looks like the same kit I bought to rebuld one. I will be giving it a go this weekend.

That is why I posted the info for the fuel lines in another post. I'm all about making a few bucks. What I have problem with is gouging or otherwise taking advantage of a situation. JIC and AN fittings are compatible with each other and since AN is a commodity item its not expensive. Paying...

Couldn't agree more.

Why are ring and pinion sets for these axles thousands of dollars each? Are there any tricks to getting a set of highway gears without breaking the bank?

The connectors were $6 each and 25’ of hose was $81. The coil of hose is enough to make 3 fuel lines. so about $35 for the one. All the parts were from Summit Racing. edit - technically you should be able to make 4-5 from the hose since the original is 58” long but replacing the line exactly is...

A reasonably priced alternative to JIC fuel hoses is to make up your own with -6 hose and fittings. Ordered some braided fuel hose and some AN6 fittings. Everything went together easily and it works perfectly.

Might be stuck brushes In the starter or a bad starter solenoid. Does the starter spin if you connedpct it directly to battery power?

I think I see the difference. I see that the transmission has its own engine speed sensor in the bell housing on the right side.

Thanks for the info. Am I reading this wrong? It looks like the engine speed sensor AND the vehicle speed sensor go to the transmission controller?? It was my understanding that the transmission needed engine speed, vehicle speed, and throttle position to work correctly.

First post here in this section. I searched around a bit to find the info on the engine speed sensor since the M1081 I recently purchased had a tach that didn't work. I didn't find a post with a concise breakdown of the problem so I decided to make one. I was thinking that the sensor was the...

Sure, it should be no problem to run the wiring in the attic assuming its rated properly and run correctly per code. People make more out of unbalanced loads than is necessary sometimes. Like most things there are not hard and fast rules here that make the decisions for us. The best thing to...

TechnoWeenie, I hope yo don't mind if I expand on your explanation of PWM vs MPPT charge controllers a little bit. A PWM charge controller doesn't actually convert any power. What it is in effect is an electronic switch that connects and disconnects the solar panels from the battery depending...

Check the voltage at the convenience outlet with a voltmeter. You should be able to adjust it to 120v regardless of the other switch settings.

Don't forget that unless you are below the balance point for your heatpump the heat strips aren't needed. They will come on during a defrost cycle to maintain comfort but that is all. The reason I mention this is its an easy thing to install an emergency power interrupt for the heat strips to...

DieselAddict - Efland NC - Chris - trackgeeks@gmail.com

I don't think it was out of line in this case since the information IS relevant to their situation.