Search results

If I can get my new camper hauler going in time I'll be there. If not maybe I'll take my little m146 there. Been wanting to go for years.

Ah wow? I think

Well there are pricey but getting a generator,heater,ac and battery charger in one seems like a good deal. The one thing I don't like is putting all my eggs in one basket.

Count me in for 2 years

3.73, 4.10, and 4.56 are the available factory gears in d60s and 14 bolts in gm pickups.

Went there yesterday it was a good show with nice swap meet. Also got to see a lot of the other camper builds I've only read about on here. Wish I could have gone today to but don't think the better half would like it if l skip out on disney two days in a row.

Well right now I heat my trailer with a 12000 btu big buddy heater. I never had it wide open even at 5 degrees outside. I thought might work good for most circumstances

Has anyone tried and apu (heater,ac,generator) from a semi to power a camper. There diesel powered and give roughly 12000 btu heat ac and 3000 watts 110AC and 50amps DC.

Painted the entire trailer inside.

Sorry if looks like I'm not working on it, but I just been on the new mega camper trailer to pull behind it. You can check out my xm971 build in the trailer section. http://www.steelsoldiers.com/showthread.php?154220-Xm971-toy-hauler

I decided to leave sunken ceiling in cargo area and recessing some areas for overhead rod holders and anything else I can think of hanging up there.

So u worked on getting the cabinets in the kitchen done. I used butcher block for the countertops, the side against the wall lifts up to gain access to the plumbing, storage and trash can.

8.3 driving procedure on soft anything. Put transfer case in low range drive forward, if reverse is needed put in neutral put transfer case in high range back up then put back in low, drive forward again cause 8.3 won't pull on soft ground and you can't use reverse in low, try this in mud hole...

Make sure you find something with a thin back, not a lot of room in there.

Got the bedroom painted, bed frame together and closet mounted this week.

Probably going to paint it woodland camouflage since I live in Wisconsin because desert tan don't blend so well. Was also thinking charcoal but probably not.

Great idea, looking forward to this build.

Yes and 3/16 aluminum sheet under that

I paneled bedroom up front and will paint it seafoam green. I'm trying to maintain a military theme thru out. also hung a few panel's in the bathroom. All corners will be trimmed out in 1x1x1/16 aluminum angle.

I got the upper cabinets mounted. As for the lowers I will paint to match the uppers and I'm also using some of the ceiling duck aluminum to trim everything out. I'm going to use butcher block for the bench surface.