Search results

Just a heads up, the 3929161 is not the same as any of the other p/ns listed. shoot me your esn and I can see if that number is a current one for your engine. I would hold off on installing them.

Seal away!!

When you put the lift pump into the system, did you go directly to the pump or thru the entire system? Easy checks first, get a clear line and go directly from a clean bucket of fuel directly to the pump, it's ok to run for a bit with unfiltered fuel. If the pump sucks the fuel into the pump and...

In some industrial and marine applications, supply fuel location is higher than the engine. If there is 250-300 gallons of fuel in the tank, how much pressure is on the inlet of the pump? Pittsburgh Diesel has been using a high output pump to force feed PT pumps for ages. To the above post, did...

While I would LOVE to, right now, laying on my back nursing a sprained SI joint. It would be great to see everyone, Aint seen 100dollarman in ages it seems. Didn't even do the pyro gig, had to cancel.

Also, if it only runs wide open, make sure the throttle shaft is not stuck in the wide open position. I have seen that happen on engines that have been dormant for long periods.

No sealant on the housing, unless it is wet. Only seal is the rear crank seal.

Just a heads up, when you swap the flywheel hsg from a SC to BC, one hole does not line up, it is the bolt hole just above the cam bore. You will need to enlarge it. I have a jig to do it at work.

I REALLY need to try and make it out there, even just for a day. Pyro trumps tho.

He really DOES have a truck! Wait....could be a stolen pic from the interwebs....

Well, it's almost 80 degrees, what's the hold up?

You can use a steam cleaner too, just remember to NOT direct the stream at one spot too long. I do this on dump trucks, trash trucks, off road equipment and OTR trucks that have plugged cores, had good luck doing this for 30 years.

Nope, it goes directly into the filter housing. Put a restriction gauge between the filter and turbo and see what kind of restriction is REALLY there. Spec is 25 in h2o max at rated load and speed

I would think that as long as it seats on the cone it will be ok.

Isn't it already a "cold air" intake?? It hangs out outside the engine compartment and is in the direct flow of air over the vehicle.

Steven, PLEASE use punctuation!

I'm just sayin', 57 pages of dangle the carrot and we got nuttin'. Your project reminds me of a jeep engine I have in the garage....but at least I still have a running, driving jeep!

Welcome back, it HAS been a bit since i've seen anything from you! Looks good, but in order for me to get another it needs power steering, front flats scare me.

Well??? I'll be retired before you get started again rofl

Just read MOST of this thread....amazing.