Search results

i used a large eye bolt and welded the joint in the eye shut

you zero the meter you are using, then measure the resistance. no further math needed.

wow! so no one has a mep-806b?? well i did verify that it is not a wix 51243 oil filter, seems that one spins right onto the block, mine has a remote filter mount with large, fine threads. for fuel it 'may' be a wix 33531, but i don't have the locking ring that attaches it to the mount.

injectors are so cheap, i would just put a new set in. cheaper than having them serviced. i guarantee yours are bad, in all the sets i have tested always 1/2 or more are not working correctly.

i would saw that is way excessive, but i have seen worse. mine is a 1974 engine that was run hot several times, has scored cylinder walls, piston noise, and for some reason has almost no blow-by.

looking for oil and fuel filter numbers for 2012 mep-806b, from what i see they don't appear to be the same as earier 806 thanks, tom

remove the line from the top of the pump and then remove the top section, the next nut. use some 2+2 gum cutter and clean the plunger. the injection system is self priming so you probably have a stuck pump.

both wheels?

yes you need a scrap yard nearby. i got the complete brake setup from a UD box truck = 2 airpacks and a dryer, then mounted a 900 series pedal assy on the firewall.

it doesn't have to be expensive. that usually happens when you cannot do it yourself. i re-engineered the entire brake system for around $400 and got an air dryer as well.

that's because when you search for 11707, you get all the meters they make. if you are not pickey about match there are many on e*** actual part numbers are: freq 72-5016 or 638-18049 amp 72-5007-1 or 72-5007-2 volt 72-5008 disclaimer: while this info might be correct, check for yourself to...

the HF scope i have is .355 so it may just fit, but it will not let you look around like you need to.

did you have someone hold the clutch in to see if it was the trans? did you remove the 3 bolts on the IP drive gear? is there a big hole in the side of the block that you didn't notice?? if all are no, you would know what 2 cylinders it could be by the position it stops turning. but in any case...

correct but there is no orientation, just a top. you can mount them anywhere on the truck, facing any direction. mine replaced the spare tire.

ok, i see the problem, that is not a part number, it is the cage code for that manufacturer and everything they make will have that number as their cage number.

that is the freq meter

dual MC, 2 airpacks, one for the front one for the rear.

i got the HF one, $100 or less and it has a wireless screen that detaches so you can fasten the camera somewhere and then drive the vehicle to monitor. the lighted camera is very small.

i don't think people realize just how rough and beat that truck really is. to me that is just barely a parts truck. the winch, hard top and engine are about the only good things there (maybe) the rest is just going to be hard to get rid of.

yeah that could be, i would just start at the front and go fishing.