Search results

I went out and looked, and sure enough... There it was.

PM sent.

Those rubber hoses inside your blue circle are attached to the transmission vacuum valve. The upper hose coming off that valve connects to a metal hard line that runs along the passenger side valve cover. This hard line travels toward the rear passenger corner of the engine and down to the...

I was really concerned about the ~1/4" of slop in the yoke of the rear axle on my parts truck. Good to know that it's normal!

Excellent links, guys! Very helpful thread, I'll be tearing into this kingpins soon. [thumbzup]

I don't own a deuce... But excellent writeup, sir! [thumbzup]

One of the holes in the lid is blown out pretty bad, I'm not even sure if a fender washer will make it right. Gunfreak, I'll send you a PM tomorrow with some photos.

This was my thought after looking at the photos.

I've got a good bottom half and okay mounting studs, but the lid is unusable... If Dave can turn up a lid, at least, we'd be set.

Those are really neat. One of those would be perfect for an M1031 with the SECM body. Wonder what they'd look like in 383 Green....... :razz:

The part number from the -20P is: 22506637 Let us know if your dealer turns anything up.

That's roughly what's being paid if you buy them directly from GovLiq in "surplus" condition and needing love. Trucks that are privately owned, titled and tagged, and freshly serviced will fetch much higher prices.

Mine was leaking from the rubber block as well. I opted to connect the lines directly to the valve. I didn't do a real thorough search (direct hookup was too easy a decision for me), so I can't say with any authority if the part is still available. His truck is the M1009 (the Blazer) with the...

Per Wix, their box filter (same as NAPA Gold 3136) is rated to a nominal 10-microns. .

The M1028 parts truck I got from a GSA auction (small volunteer fire outfit) had an open Dana 60 up front... I kept reading that the '28s had Trac-Loks, but my Dana 60 is definitely open. Hmm.

Ditto ranchhopper's suggestion, and don't forget the fusible link that connects this wire to the 12v junction block on the firewall. I had a similar problem, and I found the above fusible link on my truck was internally corroded.

Good advice, here. The battle over brake fluid gets beat to death, and a search covering the whole forum (specifically the Deuce section) will yield a lot of reading material to keep you occupied for several hours... When it came time to do a brake bleeding on my M1008, I decided to stay with...

Dang, I wish I had more time to reply to this..... Short version: it should have DOT-5 (silicone) brake fluid in it DOT-5 is usually purple or yellow, and to test, take a small sample from the reservoir and put it in a glass jar, add water to the jar, shake vigorously, and let sit. You should...

1) Paint You might try sleuthing around the Paint and Bodywork forum, there are a few threads buried there dedicated to rattle-can paint jobs, and I remember one in particular with CUCV content, but don't recall the thread's title... They should turn up with some searching, though. 2) PMCS...

I took the windshield off my parts M1028 exactly as the TM shows: remove the sealing strip from the moulding, then have Solider A sitting on the bench seat pushing out on the windshield with his feet, and Solider B holding the windshield on the outside to keep it from getting damaged... Maybe my...