Search results

Well replaced with a new switch. It was working a little better but still intermittently stopped. I can see a little of the top pin on the wire harness tarnished . I've cleaned it best I could then used a wire tie to another part of the harness ad looks to be working every time now. We'll how...

Thanks part is ordered and will be here tomorrow. I have the bezel pulled and the whole fan switch is kinda out. Maybe after I get the part I'll get a better idea how to replace it.

Found a new piece of information. The fuse wherever it is is fine. If I move the back side of the switch the fan motor runs. So I'm assuming I need a new switch? Would someplace like NAPA carry it? Any idea on the original P/N? Last how do you get the back part of the switch off?

Hi All, My fan motor switch has stopped working. It started out slowly not working and if I'd move it up and down it would start working. Now it has completely stopped. I have the dash pulled apart and cleaned all the connections but that didn't help. Then I thought duh maybe the fuse is blown...

IN

Thanks Does it mater which way mounting rails run? Parallel to the truck or perpendicular? I'm looking at these. Vantech M1009B M1000 Series Pickup Rack System on Ebay but the are $169.20

found out the left bracket is to close to the slide when taking it down. Not sure how to fix it but for now if I pull the window back towards me it goes down ok

Hi I know this is a old thread.Was wondering if anyone had any leaks or stress fractures in the fiberglass? I'm looking to do same thing on my 1986 M1009.

Hi All my rear window was cranking down a little hard sometime for awhile and I just wiggled the glass and it cranked down ok. Not it just stops half way. Any thoughts on how to fix? Can I open the tailgate with window half way down to look inside?

Saw this on Ebay and thinking about getting it. Vantech M1009B M1000 Series Pickup Rack System Anyone have any problems mounting a rack on a M1009? Is the truck cap sturdy enough? Anyone have recommendations on a Rack or any pictures?

OK wanted to know how many have driven a stock M1009 through water. How deep were you in and did you do anything afterwards? I've gone through about 24 inches of water and no issues.

Hi do you have part numbers?

Thanks that's my plan but will have to wait until warmer weather. Merry Christmas to you as well

Well looks kinda like what i'm used to so we'll see what happens haha Any gotchas I should look out for?

Hi all I know this is an old post but wanted to know if there are any gotcha's you'd like to relay? I'm planning on trying to replace the filter and fluid in my 1986 M1009 next spring. Have not done something like this since late 70's LOL

Thanks now to find out how to do that :)

Hi All, I'm hearing some kind of transmission noise when I start to take off but stops after I get moving. No shakes or anything though. I believe it's from the torque converter? Have a few questions. 1. If it is the torque converter I'm really not going to hurt anything else right if I keep...

Sounds like you have it figured out but my 1986 rear window goes about 1/4 inch inside my tailgate. Not sure why others say it doesn't?

I thought one of the problems was the pintle hook wasn't attached to the frame just the bumper?

OK thanks guys. Guess I'll be looking to borrow the truck from the friend that has the trailer.