Search results

That is a very impressive hour log, what brand is that plant with the mitsubishi engine?

May take an air hose and blow out all the lines.

I suspected those were junk, much like the aurora silent diesels that are a poor imitation of yanmar single, they snap rocker arm screws. I have been through a few junk units, the chinese heads from georgia generator that have aluminum windings, the mecce alte pto units from electric generators...

The breaker may be bad aswell. You are closing the breaker correct?

As mentioned, the seperator is a pain. They age on there, I have had luck with filter wrenches. It IS a filter, so could be stopped up...

Fleetfilter does discounts on bulk orders if you have the need. Amazon is the way to go for just a couple filters at a time though.

The 803 are good if you can get them cheap enough, every one is a gamble though, and I havent come across one yet that I would feel comfortable putting right into service. The 802 is to small/loud/shaky imho you would be better off with an inverter gen in that size range, and 6db quieter. I...

Chaffed wires, burnt ground wires, pest destruction, updates not performed, dry rot on all rubber items, switches taken apart and loosely/incorrectly put back together, over torqued/undertorqued fasteners, incorrectly fooled with fuel pumps, and lots of sand in places you wouldnt think it...

Nice

Most equipment will have a % acceptable deviation, or say, for example I have seen...50-60htz 110-120v +/- 15%

Gasoline doesnt have as much energy per gallon as diesel, and natural gas has less the gasoline.

If you have an electric water heater, range/oven, or heat pump, I recommend the 803. The 803 is the sweet spot for most people, unless you have gas appliances and furnace. You can figure it from your electric bill. In my experience you will use one gallon for every kilowatt produced regardles...

So you don't know what your hertz are? Thatll do it..

There are 5 803 on c/list in 200 mile of my area right now, all around $3500. I believe 2 003 close to me aswell. I would get the 803 personally. You are going to have to open your search distance, there is plenty out there. Take something with you to load test it to 100% for 20 mins atleast, or...

If it pulled a full 12.5 I would say the engine is fine.

The washer will be available from your local hose house for a few cents. Be sure and inspect your injector clamp, and where the clamp interfaces with the block. I had one that just wouldnt seal, turned out the clamp had been overtightened, after being loose and vibrating for many hours, it wore...

They make injector bore brushes, or you could use a barrel brush. Just make sure its brass.

Are you sure you hooked up your lines correctly? Are both reconection switches in the correct position? Has this unit been load tested/used before?

I came across two units like this, they had out of spec current transformers. I removed two windings and they were perfect...

Mine, after so many hours, went haywire. Luckily I was present and nothing burned up. I disconnected the electronic govener after that.