Search results

Honestly, if you changed turbos, you'll need to retune it. They all have different characteristics, especially if you went from a D to a C turbo.

A few of us have had issues with that front "advance" unit. I may have a spare available if you feel up for swapping another on.

Ehhh, some polymer

Use blocks of nylon, low profile and easy to replace.

Yeah, that's not too bad seen much worse. Did you do both? Does it run any different?

Nice complete post for a conversion! One minor terminology correction, they are tab filters, not spin on. This is the Stanadyne fm100 system, way better than stock imho

I'm gonna push for the weekend of the 7th(June), cause that's when I'm off this year. Hows that look for everyone else?

Valid assessment, could be water in the filters, maybe filters will help.

Just put a deuce axle under it. I have one I would donate. 2wd right?

I doubt its filters. Ive had my truck shut off while driving and up to that point, had no indidcation the filters were getting bad. I say have your injectiors pop tested and adjusted then check valve lash. Id go to the fuel system after checking the air filter. Just my 2 cents .

I've got a good takeoff. Ill pm my number if interested.

Austin Western

I was thinking the same thing, but I'd check the bottom end for cracks first.

Dump it and get a gear reduction starter. The direct drive ones are not worth fooling with.

Some leds are voltage specific, and others are "omnivolt". They are also polarity specific - if you wire it backward, they don't work. I'd sell the ones you've got and look for another set. I like Maxxima, they have a 5year warranty.

I probably do. I'll see what I can dig up.

Also, if you tackle it, leave slack in the chain around the tire. It will expand and cause issues if theres no slack. the bead usually seats around 25-30psi, so dont poop your pants when it happens. Once the tire has slid over 5he ring, the danger is gone.

They are not actually split rims, but lock rings.

5hats not 5he way its supposed to work. Usually the stop gets stripped like that when someone doesn't use 5he cable right. Have you tried twisting the handle? Some folks rotate the handle so the stop doesn't engage

If its all 3" that should work fine! A little info for anyone that doesn't know what Mike is talking about. https://www.youtube.com/watch?v=jjPeP_Nn2B4&feature=youtu.be