Search results

Hello My fuel cut off solenoid in my 1985 CUCV has gone bad. Does anyone know where i can buy one? Thanks

Hello All Can someone point me to a Thread that talks about different methods to pick up an Engine RPM Signal for the TCM on my 4L80E Swap? I have the MSD TCM already I'm wondering if anyone has dealt with this yet. Thanks In Advance

Hello My Dads master cylinder went bad on his 1985 M1028 I'm trying to order him one from AutoZone and they're asking me which brake code I looked in the glove compartment and can't find that code. Can someone please tell me which master cylinder I should use my options are JD5 Takes one number...

Can anyone with a M1028A2 take a weld to weld measurement of there front drive shaft? It has to have the NP205 and be the dually at stock Height. Thanks in advance.

I was wondering if you could help me? I just converted my M1028 from the NP208 with no PTO to a NP205 with PTO [I'm building a dump truck] Is there a chance you could measure the front drive shaft in your truck and give me a weld to weld measurement of the front tube? My orignal shaft is to long...

I just pulled the NP208 out of my 1985 M1028 to swap in a NP205 W/PTO before I started this swap I called the local dealer I deal with to make sure this was a direct swap the doner vechicle was also an 1985 1 ton non military Chevy 350[Gas] with a Turbo 400 I was very clear about the question is...

For starters I purchased this truck through a friend that worked on a Naval Base. When I got the truck it had a starter button and was also beening started with either.After reading some threads I repaired the starter issue by replacing the starter relay and the either issue by installing new...

Is there anybody who might know the part numbers for the "REAR" sway bar links for my 1985 1028 dually and where I can buy them. I called two Auto Part stores and both said there's no listing for rear sway bar links. Thanks In Advance For Any Help, Greg

OK after reading as many posts as I could find I'm not sure what I have.I thought my truck was a M1028A2. Here's some info if any body can help.I'll start at the front - on the front bumper are painted two different letter number combos looking at the truck on the left of the bumper I can make...

I tried to contact POOR WHITE BOY via a private message but he hasn't logged on in a while. Is there other way to contact him?If not does anybody know him and might be able tell him to check his PMs. Thanks

I'm looking at a cube van from GL it's a 6.2 but I can't tell which trans it has I heard these vans had the 4l80e. Can I tell by the VIN.#? I'm looking at this van because I want to do a trans swap into my 1028A2. Thanks in advance for any help!!