Search results

Got the truck painted. Now for all the small stuff. And paint the other rims.

Painted 6 rims and put them back on the truck. Still have to paint the bed. And the other 5 rims.

275 for 12 rims

Picked up my rims from the sandblaster and stopped at Idaho Motor Pool and got 4 new tires.

I am speechless. I hope mine looks half as good as yours. What did you use for foam in the hard top?

Just kinda wondering what others were using. Probably will use grade 8 and check them after a while.

There is no marking on the studs. Grade 8 bolts are brittle and grade 5 will stretch some before breaking. I know grade 8 is not always better.

The studs that hold the front spindles on are they grade 8 or 5? I look around and did not find what I was looking for. Thanks

Your truck gives me motivation to finish mine!

Did you mix it well before spraying?

Sorry the pictures are out of order. I painted the door with 24087 Bear exterior paint. But decided to paint it with Rapco 24087. I like the color better. And my wife bought me seat covers from Jatonka for xmas. As soon as the cab is all prepped I am going to sand blast the bed and patch some...

Well here is a update. I work allot so I don't get tons of time with it. I found quite a bit of rust on the truck. Both sides under the door's were rusted out, the windshield frame was rusted out and the cowl was rusted out in spots. But making some progress as time allows.

I bought a orbital sander off the Mac truck. And a Husky paint sprayer from Home depot. I pressure washed the truck before starting. I been sanding the truck with 80 grit sand paper. And replacing rusty hardware with new. Bought 2 gallons of Gillespie 24087. So far the truck looks good.

Seat covers look good! My wife bought me a new set too, Just have not mounted them yet..

1968 Kaiser M35A2 W/W Serial number---------053910301 Registration number: none NSN number----------2320000771617 It was bought from private seller in Elko NV Bumber# painted over Thanks for the help Aaron

Got mine at Napa. 27 bucks

With the master s/w closed one of the "11's" sends power down to the Alt through pins C and D. The other "11" sends power to the low air pressure warning buzzer and Fuel pump motor through pins A and B. Looks like the horn circuit breaker and the number 15 wire going to the light switch all...

I am not a big fan of normal but connectors. I try to solder and heat shrink everything I can. They also have a solder type but connector out there that are easy to use. Just insert the wire and use a small heat gun to melt the solder inside. Then the casing melts around the solder to from a...

Pulled the winch off and replaced the seals in it and sandblasted and painted the winch...Not sure if i like the green. I had Carquest try to match the paint.

started to replace a leaky compressor gasket. And replaces some missing screws in the doors.