Search results

Fellows- OK, so I'm getting ready to set the fuel system up on this puppy, and I'm going to use a Goldenrod filter, so it will take very little pressure to get fuel by the filter. I have a tank outside that I'll fill, a 275 gallon heating oil tank, and it's elevated, the bottom is maybe 3 or 4...

Hey Folks, I'm converting over an Onan MEP 002A Engine for use with a DC Motor that I plan to use as a DC generator, and I'm looking to find out if anyone knows how long of a pipe/etc will develop too much backpressure? I want to run the exhaust outside of my garage, to quiet it a little, but...

While I realize that someone has abused the system, and evidently that's why are required to yak about everything on this site in order to get to 100 posts to post classified, I think it's seriously unfair to those of us that have been coming to this site for years. I also realize that by...

OK folks, I have one I think you might like. Had my 86 dashboard apart, replacing bulbs, installing new lense etc, and a replacement fuel gauge. My speedo always read wrong, and made irritating scratchy noises while I was going down the road, and I'm too cheap to have it rebuilt. Took it...

On Tuesday; I'll be leaving for Nellis from Coeur d'Alene, ID to pick up my #2 M1009. Won it in the beginning of December, EUC just came through. I want to drive it home, so I hired a small company to go & get it from Nellis for me yesterday. They inspected it; I had them puere's what we...

Greetings all- Yesterday, I wanted to fix a front main leak on my 1986 M1009. We took off the timing cover; and....ooops. The timing gear & injection pump gear were covered, and I mean like ridiculous overgrown monster covered in rust. This stuff was fairly nutso. Making a long story short...

This morning, after doing a lot of work on my M1009, I decided to go ahread & replace the Glowplugs on my CUCV. I had bought 3 sets of ACDelco 11G (60G) Glowplugs, and since my rig was starting a little slow, I thought I'd fix that. So, I installed them. Cut off the ends, replaced the ends...

I have a set of doors that close, but not all the way. In other words, when I close the doors, they close & latch, and seem tight when first closed. Then, as soon as I hit the first minor bump; both of these doors will go in & out (open/closed direction) about an eighth of an inch. I don't know...

Hey Folks- I'm fixing all the stuff on the dash board of my 1009, and I can't seem to find anybody who sell the "Gen 1" "Gen 2" "4WD" covers for the dashboard. Any ideas? Thanks- Chris