Search results

Whats the normal operating temp for the 2.5 Rockwell axles differential/chunk (mainly the rear b/c I don't have front driveshaft hooked up all the time) & what temp is considered "not" to exceed. After about a 30 mile run at 60-65MPH my pinion nut on rear is pretty warm. I'm not asking about hub...

I need to know what the spindle thread size is (diameter, threads per inch), basically size of the nut.

Back in October I put all new bearings & seals in front & rear axles. Took front apart to clean it up after going thru some mud (only taken front apart so far, rear axle is M35A3 so I'll check them later different style inner bearing) & it looks like it never had a seal there to begin with...

So basically I just undo tie rod, steering arm. Remove plate, sleeve housing & sleeve. Now does it just lift off or is it keyed some way in order to remove? Thanks in advance for any help.

I'm looking for the SRW 14 bolt rear & Dana 60 front that are in the M1010. I'm not sure if the other CUCV's are the same width or not, if so then they'll work just as good. I think the M1010's are 63" WMS-WMS (don't quote me on that) I could be wrong about that. I just assume it because all 14...