Search results

Check all the vacuum lines with a mytivak . Replace line that has become hard. Also, get a new modulator for a diesel turbo 400. I bought a Rostra 51-0020-00-00 Black/Red Stripe Vacuum Modulator. Fixed my problem on late hard shifts. Seems like my truck all the rubber died. Trying to bring...

The fuidampr has been discussed quite a bit on this site, use search. I went to Rockauto and the Dayco is in stock. It is what I bought and is the same dampener as the powerbond with the same part number.

Pioneer is made in AU. Try rockauto dot com that is where I bought mine. I had to setup an alert to notify me when it was in stock. Don't delay after the notification.

Fluidampr is $564+freight+tax. Nope.

Do the beds on these trucks just buzz and rattle at idle or am I missed something? I've checked to make sure nothing is touching the frame. The engine, trans mounts are all good. The exhaust is not touching anything. The buzzing is on the bed and the tank so the vibration is frame related...

Looking forward to 2 batteries. Thanks.

Right. All I know about this truck is what I have repaired that was broken. I did a manual glow plug system, fixed wiring issues and reconditioned the batteries to 100%. That produced an easy starting truck with very little cranking. I have a long list of other issues but, now I feel I could...

I would call Offroad Design and see if they could give you the part numbers. You might just buy them from ORD.

This one was on the plate This one was connected to the harness dangling The one on the left that was not connected looks close to welding shut.

I've been checking all my grounds and going over all the wiring for the GP system. In the Electrical section of "CUCV Helpful Threads", Electrical Ground Locations, it states this: Diagram E-3 - Main Battery Ground - 2 gauge black from Negative Term Board behind rear battery - attaches to the...

It could be the PO just shorted out something to cause the unknown resistor to blow. Can someone tell me what the resistor is so that I could test the board? I do plan on having a manual momentary GP relay switch in the truck. I would also like to know what usually dies on these cards. The...

After looking at the bolt hole in the bock, I am going to need a tap. It's rough and that is the problem. I don't know why I thought I was just poking it into the hole, the shield made me look like a fool. I will have to get it into my shop and remove the starter for some room. This little...

Manual says GM 14060613 BOLT,MACHINE. GM says M8 1.25x20mm. The block bolt is way larger. Anyone ever had a different size in the 6.2l ?

IN

IN