Deuce Rear Lug Stud Question

[hangfire]

I have a question that I have not found a definitive answer to reading the TM's, Searching the Forum, Goggling, Binging, Yahooing, You tube, So I am now asking the experts here.

Is it possible to change out 1 busted rear left lug stud with out pulling the axle and hub?

In the schematic’s I just can not tell if the hub must come off or not.

I will thank you now for your help to my question.

Thanks, Mike

 

[3dAngus]

New studs for your M35A2 are $7.50 from Eric's surplus. I got four in today for my parts kit. Be sure to specify the left or the right as they are reverse threaded on the other side.
I don't know how you would press them out without removal of the hub.

 

[gimpyrobb]

 

[Flyingvan911]

Studs on the left side turn in reverse. Left-tight, right-loose. I forgot that a while back and it made the tire change twice as difficult.

 

[mikey]

No, gotta remove the hub.

The good news is you can't find a better guide than this for removing your hub and pressing the stud out:

Hub Flip

 

[hangfire]

Thanks, I was thinking that I would have to pull the Hub but was hoping for a short cut. I have th estud seals and gasket on hand to do the job.
Thanks, Mike

 

[mikey]

Thanks, I was thinking that I would have to pull the Hub but was hoping for a short cut. I have th estud seals and gasket on hand to do the job.
Thanks, Mike

MikeW is a member here. Thank him when you get a chance. That is one **** of a write up.

Steel Soldiers::Military Vehicles Supersite - View Profile: mikew

Mikey

 

[3dAngus]

What about new axle seals?