• Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!

  • Microsoft MSN, Live, Hotmail, Outlook email users may not be receiving emails. We are working to resolve this issue. Please add support@steelsoldiers.com to your trusted contacts.

M35 IR driving light

st8drumz

Member
64
10
8
Location
Romeo, Mi
Been looking through threads trying to find tips on putting an IR light on my A2 but haven't been very successful. Need recommendations on location, wiring, etc. I was looking at putting is on the bumper between the headlight and turn signal and then using the wiring from the blackout driving light (rerouted). Thought the dual connectors on the back were + and - but cracked it open and discovered that the ground is the post. Any thoughts would be appreciated! THanks in advance!
 

rustystud

Well-known member
9,241
2,925
113
Location
Woodinville, Washington
Been looking through threads trying to find tips on putting an IR light on my A2 but haven't been very successful. Need recommendations on location, wiring, etc. I was looking at putting is on the bumper between the headlight and turn signal and then using the wiring from the blackout driving light (rerouted). Thought the dual connectors on the back were + and - but cracked it open and discovered that the ground is the post. Any thoughts would be appreciated! THanks in advance!
The front bumper is a good place. The dual connectors are for Hi and Low beams.
 

CARNAC

The Envelope Please.
Supporting Vendor
8,283
644
113
Location
Corpus Christi, TX
The options listed have all been done. The underside of bumper was where mine were. Yep both connectors are pos. Ground through mounting post. Did a thread about this back about 2007 or 8.
 

MWMULES

Well-known member
Steel Soldiers Supporter
In Memorial
5,580
346
83
Location
DESOTO, KANSAS
Mine have the clear lens in now but wired them to the black out drive circuit. I just used the high beam lead.
mrap bump.jpg
 
Last edited:

st8drumz

Member
64
10
8
Location
Romeo, Mi
How did you do that with the high and low beam sockets? Or did you just up for one of the other?

Sent from my LG-LS980 using Tapatalk
 

st8drumz

Member
64
10
8
Location
Romeo, Mi
The options listed have all been done. The underside of bumper was where mine were. Yep both connectors are pos. Ground through mounting post. Did a thread about this back about 2007 or 8.

Looked in your thread history for the info you mentioned but didn't see it. Would it have been labeled relative to the topic (I assume)? Also, are you still doing vehicle info?
 
Top