Ddmk18
Member
- 272
- 2
- 18
- Location
- James Creek PA
Hi I am looking at a mep-002a to purchase this will be my first one so I dont have much experience with them. The one I am looking at the guy had removed the ip and rebuilt it but never reinstalled it. He wasn't sure how to put it back on properly so we installed it today it was the orginal one off the engine, he had the shim in place and used the same button over again. We turned the engine over to the PC mark on compression for number 1 cylinder and put 1/8 inch drill bit in the alignment hole on the pump. After bolting it all together and bleeding it the gen runs for about a minute or two and gets really hot then starts losing power and we shut it off, after we let it cool we started it back up and it did same thing. So my question is what could be causing this? Pump not rebuilt properly or injectors or could it be the timing?
Thanks for any advice Dillon
Thanks for any advice Dillon