nattieleather
Well-known member
- 1,882
- 149
- 63
- Location
- Cleveland, OH
I've done did a search and haven't found the answer so I'm posting. HMMWV rims are 16 x 8 is that correct?
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Rim Size
- Thread starter nattieleather
- Start date
- 34,010
- 1,823
- 113
- Location
- GA Mountains
16.5" dia fpr sure but width is a guess at 8.25"
Kenny is right about the diameter not sure about the width. Get with a fella on here by the name Gunchief hes the Humvee guru and should have all the answers to your humvee?s He lives here in TN and is building a few trucks. Sold him the radial and beadlock I had.
actionpaintball
Member
- 171
- 2
- 18
- Location
- Hayes VA 23072
Stock size is 16.5x8.25
They never made a 16" wheel to be my knowledge
They never made a 16" wheel to be my knowledge
nattieleather
Well-known member
- 1,882
- 149
- 63
- Location
- Cleveland, OH
You know I meant 16.5...sorry about that. I didn't know they were a 1/4 inch bigger in the width.
Barrman
Well-known member
- 5,371
- 2,030
- 113
- Location
- Giddings, Texas
Joe,
If this is for your M37A3 project, I would advise you against the rims. I thought they were neater than sliced bread until I started messing with them during my M101 repaint. I had a pair of both versions and both style of run flat inserts. They don't inter mingle and they are a pain to seal up. I think 3 different o-rings were used over time and you have to have the correct ones for your rims. Actually, you need new correct ones to make them hold air. I just slobbered a bunch of wheel bearing grease on my used o-rings and it worked.
I know they look cool, but a set of painted 1 piece tube less rims will be a lot less hassle. Cheaper too.
If this is for your M37A3 project, I would advise you against the rims. I thought they were neater than sliced bread until I started messing with them during my M101 repaint. I had a pair of both versions and both style of run flat inserts. They don't inter mingle and they are a pain to seal up. I think 3 different o-rings were used over time and you have to have the correct ones for your rims. Actually, you need new correct ones to make them hold air. I just slobbered a bunch of wheel bearing grease on my used o-rings and it worked.
I know they look cool, but a set of painted 1 piece tube less rims will be a lot less hassle. Cheaper too.