motormayhem
Member
- 627
- 18
- 18
- Location
- Tucson, AZ
Hey I just re-cased the tranny in my m1009 and everything went smoothly. I reinstalled it and filled her up. I put it in drive and reverse about 15 times untill it was shifting into gear strong and went for a test drive. Now it doesn't leave 1st gear unless I shift from drive to second give it a sec and then put it back into drive. If I do that it will shift from 1st to second and then when I do it again it will go from 2nd to 3rd without any problems. I have vaccume at the modulator and the governer is good. Also it seems like it sometimes will stay in whatever gear it was in when I stopped (eg. starting from a light in second untill I downshift it into 1st). What is uo with it? The fluid level is fine. I know when I reinstalled it everything was "clean", but had some dirty tranny fluid on the parts. Do you think it could be as simple as a new filter (didn't replace it
)? I was planning on going for a trip to the mountains wednesday night, but now that is up to my tranny.
Any quick help would be GREATLY appreciated,
Miles
Any quick help would be GREATLY appreciated,
Miles