Tab Content
  • NDT's Avatar
    06-23-2019, 19:02
    NDT replied to a thread Fuel cap hole? in FMTV
    Me thinks that is a field mod used to pressurize the fuel tank to get fuel flowing fast to the IP etc.
    11 replies | 108 view(s)
  • NDT's Avatar
    06-23-2019, 18:54
    Are you saying no more will be sold from the bunch that was transported from CO to PA?
    74 replies | 2959 view(s)
  • NDT's Avatar
    06-23-2019, 18:46
    NDT replied to a thread Cucv ii 99k 559 in CUCV
    Ah you have some learning to do grasshopper. The CUCVIIs have (had in your case) 24 volt starters, and a solid state 12/24 volt converter to charge...
    3 replies | 116 view(s)
  • NDT's Avatar
    06-23-2019, 18:37
    EUC? when did that start for FMTVs? Couple of data points, your truck likely went through a rebuild given the upgraded marker lights and front...
    9 replies | 150 view(s)
  • NDT's Avatar
    06-22-2019, 18:31
    Aaron and subsequent, the ramps I had are all gone. Suggest anyone needing them skip the military 400 lb units and buy aluminum ones.
    16 replies | 707 view(s)
  • NDT's Avatar
    06-20-2019, 21:40
    Welcome! That is one nice M38A1! Someone did a lot of restoration on it. You want 10W30 petroleum oil in your engine. The canvas top does have...
    6 replies | 88 view(s)
  • NDT's Avatar
    06-16-2019, 01:07
    NDT replied to a thread 1953 M37 vin in M37
    On the hardly readable data plate.
    6 replies | 196 view(s)
  • NDT's Avatar
    06-13-2019, 12:43
    Transmission is not in any way connected to air system. If you are applying brake to shift to reverse, maybe this is what is making you believe the...
    4 replies | 106 view(s)
  • NDT's Avatar
    06-13-2019, 00:07
    NDT replied to a thread Hobbs 901DS in Trailers
    That is worth saving. It's referred to as a 1 ton trailer, it's WWII, usually made by Ben Hur.
    1 replies | 98 view(s)
  • NDT's Avatar
    06-11-2019, 01:37
    See if a local drive shaft shop is available to re-tube yours. Cheaper usually.
    1 replies | 84 view(s)
  • NDT's Avatar
    06-10-2019, 12:08
    NDT replied to a thread Driveshafts in FMTV
    Axle pinion is parallel to frame. So there is the allowed 2 degrees.
    39 replies | 679 view(s)
  • NDT's Avatar
    06-10-2019, 10:56
    NDT replied to a thread M1079 runs hot and shuts down in FMTV
    Any chunks of plastic floating around in the cooling system will for sure end up plugging the radiator tubes, leading to overheating. Flush...
    4 replies | 147 view(s)
  • NDT's Avatar
    06-08-2019, 15:53
    NDT replied to a thread Driveshafts in FMTV
    How did you find that the factory drive shafts are unbalanced? They were removed in the field by Stewart and Stevenson employees and destroyed. The...
    39 replies | 679 view(s)
  • NDT's Avatar
    06-08-2019, 05:33
    The front brakes are not part of the parking brakes. Does the front brake release with zero air pressure in the system? That would mean air system...
    39 replies | 570 view(s)
  • NDT's Avatar
    06-07-2019, 15:34
    NDT replied to a thread M915A1 Governor Help in 5-ton and up
    There were no civilian M915A1s. 58 mph is against the governor, that is all any of them will do. Just takes a little longer to get somewhere that's...
    7 replies | 129 view(s)
  • NDT's Avatar
    06-05-2019, 16:03
    Yes, the price our country has paid for freedom is significant. Just took a similar picture myself.
    3 replies | 212 view(s)
  • NDT's Avatar
    06-02-2019, 16:24
    NDT replied to a thread Seized my engine! in The Early Deuce
    Yes the distributor drives the oil pump. Can say for nearly certain this was operator error. Is the distributor dimensionally identical? You will...
    23 replies | 856 view(s)
  • NDT's Avatar
    06-02-2019, 07:45
    NDT replied to a thread Is this a M7 or M17 in Trailers
    A 4' round hole pattern could be for quad mount. Rectangular pattern could be generator. Director would have holes to attach the house.
    5 replies | 207 view(s)
  • NDT's Avatar
    06-01-2019, 08:39
    NDT replied to a thread Is this a M7 or M17 in Trailers
    There were many uses for those such as generator or director. Hole patterns may tell the story. Likely from Holloman NM. A little overkill for a...
    5 replies | 207 view(s)
  • NDT's Avatar
    05-30-2019, 13:58
    I saw my first skysweeper AA towed gun at Leo Porter's yard in DFW years ago. He said he towed it there with one of his Chevy repower M715s. Later...
    18 replies | 579 view(s)
No More Results
About NDT

Basic Information

About NDT
Biography:
Been involved with military vehicles and equipment since I was 15 years old.
Location:
Camp Wood/LC, TX
Interests:
Comm equipment, shelter carriers, line haul trucks, equipment transporters, engineer equipment
Occupation:
Manufacturing Engineer
MVPA:
4954

Statistics


Total Posts
Total Posts
7,134
Posts Per Day
1.86
Total Thanks
Total Thanks
2,067
General Information
Last Activity
Yesterday 17:52
Join Date
12-21-2008
Referrals
1
iTrader Profile Recent Ratings
Feedback Score:
Positive Feedback:
26
100.0%
Members who left positive:
Members who left negative:
26
0
Total positive feedback: 40
Submit Feedback For NDT
View Complete Feedbacks for NDT
  Past
Month
Past
6 Months
Past
12 Months
  0 0 0
  0 0 0
  0 0 0