Recent content by 67 evil eleanor

Jsut that. I have looked and can't seem to find one. May have over looked it so forgive me if so. Anyway, thanks for your help.

Again I was kicked out or the server but thanks for your help.

I'm not sure how to use the tms. Anyway this is not it. It is where the fold ups lock the nut on top of the sector. I would imagine there's a civie vehicle that shares the same set up. Anyway I'll try again.

Sorry but I have looked for two days for a kit number for this. Leaking out of the top of the sector. Thanks for your help!

KDS is green.

Just trying to figure out what is going on. My 998 kds green start box will cycle the plugs normally when it's raining and the vehicle sitting outside. When inside and in the dry the wait light will flash only for a second and the plugs will not heat. I cracked the box to take a looksee inside...

Fixed. It was the insulators in the mid and sides of the hood. I knew they was worn but didn't think bad enough to cause this. The "tip" was I noticed a bolt that had been rubbing against the hood and then used a couple of 1/4" rubber bushings to test. All squeaks stopped. Just received the new...

Will give it a try. As far as I know all parts like u joints and ball joints are fine and in good working order. I've been around cars and built cars all my life and to me it sounds like a surface like rubber to rubber or in another situation I had fiberglass to fiberglass. This one has been...

Checked that. Have grease fittings on all ball joints and very liberally greased them. Just wondering if it's where the aluminum panels are rivited together and there is some movement.

Took off the doghouse and used armor all on the seal to test. No differ.

M 998 when I first start driving there is no squeaks. After about 5 minutes the whole front dash of floor starts squeaking like crazy. I have tried to locate a certain area but it seems it's the entire width of the front. Also I removed the speedo cable and lubed it with a graphite anti seize...

It did fire up after charging the batteries. He still thinks the GPs are not working. Reading over several threads do you guys think it maybe could be a ground that is not 100%. Seems to be a never ending problem on these vehicles. I do plan on making a ground harness for my 998 to make sure...

It has the factory original switch. He will check to see of it's staying closed when in the off position.

On a friends 998 his start box toasted one night while sitting in the garage. He ordered a replacement box and sender and swapped the box out but when he reconnected the batteries he could hear a solenoid clicking in the box. This is with the switch in the off position. On thing I noted was...

Not sure if this is the right place to post but anyway I have a nos 11.00-20 Titan T Hawk 373's. Have 10 new stored inside my garage for the last 10 years and they all have the inner liner. Thanks for your help and I hope I didn't put this in the wrong spot.