Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Microsoft MSN, Live, Hotmail, Outlook email users may not be receiving emails. We are working to resolve this issue. Please add support@steelsoldiers.com to your trusted contacts.
The only information I can find is on the directions and diagram on the inside of the lid. I have looked for a manual but havnt been able to find one yet
Will this one work for my MEP? I'm not looking to do lot of load testing just trying to check a few things on my MEP. I love the design and the portability of it but will part ways with it if it wont work with my setup. Thanks Bernard
The gov took it back after you paid for it? Have you picked it up? Will it work with a Mep 005a? What did you pay for yours? I paid right at 400 with the taxes and fees. Thanks Bernard
It says. 1. General. The dunny load is designed to perform electrical loading tests on power plants rated either 28 volts or 120/208, 3 phase, 4 wire, 400 cycle A.C.. Both Dummy load systems (A.C. and D.C.) may be operated individually or simultaneously without influencing each other's loading...
I was wondering if anyone had any info on the "carrier bearing located at the end of genny near the cooling louvers and control cubicle? It's shown in the tm-34 page 295 figure 5-36 #22 carrier/housing and #23 is the actual bearing. I start my genset up about once a month and apply about a 50%...
Part came in. Installed it and guess What? Everything is working just as it should. Hertz meter is reading 60 where I had the throttle adjusted at, and voltage is reading correct. Thanks for all your help Guyfang and I hope others will find this post helpful. If anyone has to replace the thermal...
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website like our supporting vendors. Their ads help keep Steel Soldiers going. Please consider disabling your ad blockers for the site. Thanks!