Recent content by cubdriver55

Can anyone tell me if military part number 2530015554749 is the right wheel for Super Singles on an M929? Thanks Steve

The bed is not dented up and it has a metal top which was a part of the rebuild. It also has a heater. Good solid truck not rusted.

I have an m817 dump truck that I am looking to sell and I was just wondering if anyone had a idea of value? I looked a long time to find this truck when I got it. It is one of the few that went thru the rebuild process and was completely redone 2000 miles ago. They added a different trans so it...

Can the plunger be moving freely but still not turning fuel on?

I have a m235a2 and it has been sitting about 4 years. I tried to start it and it was not getting fuel. I think the tank was too low and I ran all the fuel out. I put 10 gals in and the pump is working and returning fuel I bled the screw between the 2 filters and have fuel there. I can not get...

Can anyone tell me if the Yanmar conversion of the 16a has a starter and battery with charging system? I have decided the 802A s I bought are too big for my application I am now thinking the MEP-016d s would be a better choice. Now I have to find a home for the 802 a s. Thanks Steve

I have several questions about the MEP-216 Generators. Can the Yanmar diesel conversion be put on any of the 016s or just the gas version? Will it work on a 016b for example? I have some of the MEP-802a generators but I am taking one to the bush where it will only be charging batteries that...

I am looking to trade an 802a for a good 016 or other 3 kw generator. If anyone is interested ;et me know.

Yes it is the circuit interrupter relay which is the big one under the top lid. I will try to find which relay behind the panel controls it. I have another unit that I can borrow parts from to see if it works. Where can I find an electrical diagram of the unit? Thanks steve

Yes I tried battle short. I have the manuals but no electric scematic. I doubt if I could read it anyway. I have voltage to the transformer or what appears to be a transformer. ( The large square box that the load wires go into right before they go to the output lugs). I have voltage going in...

I have an 802 that starts and runs fine. The voltage and htz are good and the receptacle works fine. I can not get any voltage to the lugs on the bottom. I tried an Ac circuit interrupter from another generator and it did not help. Any ideas? I also have another 802 that does produce elec but...

Also it does not use any brake fluid the master stays full.

The truck sat about 8 months but the brake pedal went way down before that but the brakes worked now they do not work. There are no leaks anywhere. The pedal will not pump up at all but does appear to be working. You can hear one of the rear shoes moving when pumping the pedal. The pedal does...

I have an m-817 that the brakes went almost to the floor but worked when I got it. It has been sitting and now the brakes go all the way to the floor and do not work. I was going to start by adjusting the brakes but after loosening the large nut I can not find anything to fit the inner adjuster...

I got 4 of the last units and was able to come up with NAPA filter numbers. NAPA has a filter sale going on now so they are not too high priced. NAPA numbers Oil 1374 $4.80 Air #2276 $13.86 Primary fuel # 3472 $8.58 Secandary fuel # 3348 $ 3.87 Hope that helps