Recent content by dan labarge

I tryed about eight times,way to hard.1st time one error 2nd time threee errors. I did ask for help and my wife couldnt get it eather after many trys.Sorry maybe i am big dummy?Tryed again and any way I wright 7000 it says error,and I would never post anything if it wasnt mine nget this much...

I tryed posting my m37 in the classified with no luck so check it out on craigslist in Maryville tenn. in farm n garden or cars n trucks ,will trade for tracktor mower sidebyside cycles ? Dan

i tryed with no luck to put my m37 on classifed for 7000 or trade for mower tractor sidebyside or cycle check craigs list maryville tenn.

maybe start by taking it off the truck so when it brakes like mine did,you'll have it on the bench and fixit faster. Dan

i have a rotor kit on mine,you can have my front backing plates if know anyone goen this way.

the long rod goes next to the trans.the rod next to the trans driveshaft is in the middle and theone near the front driveshaft on the outside

I forgot to ask wear can i get some longer shocks for my lifted m37 ,anybody? thanks

I took off the brackets ,slide rails from a set of buckets and made driverside a pedestel out of one inch angle iron to getit level with the otherside.used flatiron bolted to the bottom of both seats to mount waer is comfortable for me.not adjustable but i put as far back as possable

maybe a coil or condeicer ,had to replace mine .

I would cover the blocks to the frame with some nice thick flat steel to safe it up ,looks good though.

its not yours till you make it yours, hard work and lots of money to get it right.

I bought my m37 with a snowplow on it ,and the motor knocked from the hi reves from pushing snow and the trans was mesed up . I paid the sameprice and now have allmost 5,000.oo more into it doin the work myself . Thanks everyone for great pics and info.

has anybody had a crome molly axle shaft made for m37 or swithch two a 35 splind in spool.i broke short side and was thinking about upgrading

burned up my belt had to unhook bat. cable to stop spining,ign.in off pos. I think this might have happen before but didnt see it,but belt was broken.any body have ideas?:?::smile:

:?:i am going to put a disc brake kit on and would like to redo front n rear axle seals w/ up dated rubber insted of old stock, i tried to down lode xref page and no luck please help if you can thanks:razz: