Recent content by Jayrassic

Do you know what cable you are using to connect the two?

Thanks for this information. I tried running a 671 through a C-2298 hooked to an AM-1780 with a CX-4723 cable and had the same results as you. Going to try it with a CX-13292 and see if that works! Thanks!

Stirring up an old post. Looking to add a vic 1 to a humvee slantback but am curious about the mounting brackets... What to search for and where to find them. Ebay seems to be dry for such a thing.

I am looking to buy one that already has a title in Wisconsin so the usual affidavit of police officer and then just registering for the road. What BMV do you use? From your list of vehicles they should know you lol.

Well with the m813 on the road thanks to you guys, have any of you registered an hmmwv in Indiana? Thinking the m813 needs a playmate.

Madness, pure madness I have never flipped an on off switch back and forth back and forth slow fast faster slower while pushing in while pulling out just thinking I will see a gauge come to life, and the wonderous sound of the low air pressure buzzer kick on... the sound of glory that I can now...

Does anyone know where to get some scraps of old cargo tops? Have 3 to 4 1"-3" diameter holes I'ld like to fix.

Just wanted to say thanks to all that provided their insight... Right Front paw is all back together and had her out for 30 miles and rolling good with a hub that is staying nice and cool now. I did have one part left over from the kit I bought from OshKosh it is a hub seal wiper, intended to...

Thanks man I really appreciate the info. That certainly does make sense.... off to find a slide hammer to get that bugger out.

are we speaking of the same seals on the spline?

Finally made its way to the bench and getting ready for some cutting. There was what looked like a black silicone sealant all around and in the bolt-holes. I dont see mention of it in the TM's and the "P" TM. Should a sealant be applied for the reassembly? Since I'm this far is it recommended to...

So I have come to the conclusion after not seeing a part like this in TM diagrams the hunk of steel left here is the remainder of the inner bearing... how on earth does one get it off I've banged, I've pryed, I've prayed, I've chiseled... any other tips?

How'd you get er home? just realizing thats a rumble strip alongside the highway!

well we looked at each other when we stopped at a red light and said thats a new smell... kinda smells hot? pulled over spit on the hub... sizzle sizzle ran into the store for a couple gallons of spring water and started cooling Big Chubby down.... maybe a good time to switch all out to some...

Oh you like em well done!! Lol