Recent content by kenny

No never heard of them I want some. Where can I find them?

I had a 1978 350 gas engine do that. I welded a new key way in place pounded the balancer back on with a 4x4 post and sledge. It lasted 4 or 5 years later then I sold the truck. I feal bad for the next guy that tries to remove it for a rebuild

"""fan 12 volt.""" the standard steering column should work,,,"""dash lights head light switch"""blinkers""" bulbs, Ground, or the blinker switch

I keep panty hose in all my trucks just incase of this. ""Not to hitch hike home LOL!!"" but to use as a temp belt for the water pump. If you put it on tight and cut the loose ends off so there not flopping around it will last about 15 to 20 minutes. Glad it is ok.

Change the calapers. One of them is sticking and it is not normal for any year suburban UNLESS it has drum brakes in the front and one is out of adjustment to pull to one side or the other

Mine leaks on both sides of my 1008. And most civilian trucks in that year had rain drip rail over the doors.

I also wait for the volt meter. it takes 3 to 5 seconds longer than the light

You can replace the gasket or use the old one with clear gasket sealer.

Spray Foam the stuff at Home-Depot Called TUFF STUFF And it makes better faster repairs in rust holes than bondo. and did I forget to say it stops any thing that vibrates, rattles or shakes and does wonders anoying neighbors loud honda tail pipes.I have not been woke up at 2:30am sence.

Same with my 1008 and it wont down shift after about 40 or 45 MPH It wiil shift to 2nd at 10mph and to 3rd at 15mph if I just push the throttle1/4 of the way down. ""456 Gears""

Nice Truck!! You can make the death wobble go away for 25 dollars.

I agree. I would pull the pan and pull the caps off and look at the bearings. If the crank in not all screwed up you might get away with just replaceing the bearings and oil pump, If the crank is realy scored bad take it to a rebuilder and have them resurface it. About 3 hours of work on your...

it might be that front output shaft front bearing is loose. Have you grabed the CV part of your drive shaft and checked to see if it moves up and down. it should not move at all up or down Your seal will leak if the bearing is to loose.. Tnansfer case OIL LEAKAGE CAUSE 1. Excessive...

Sound good!! thanks for the video I think you might want to test to make sure all your glow plugs are working. It should have fired right up for the time you waited for the glow plugs to heat

I have a friend that had a 1986 18 wheeler with 300 hp diesel that put his used motor oil that he took out of his own engine and put it right in his fuel tank but I dont think he would go as far as E85. I would not put it in mine or motor oil for that matter.