Recent content by m35 adam

yes, looks to be all hooked up.

picked up a 1994 mtv wrecker with 738 miles on it. All the fluids where drained. Filled all the fluids and the truck started right uo and drives great. I put 70 of hydraulic fluid in the tank. Says it takes 73 gallons. I filled it to the full line. Here's the problem, The fluid pushes out of...

it's like new air is getting in the system. Just won't hold pressure in the line. Sounds like the little hand pump is bad. Thanks

Cool, thanks!!

Hi, just picked up a mtv. 3116 cat. it cranks and will kind of start after pumping the hand primer. Then I have to pump the hand primer again. I don't see any leaks in the system but seems like air is getting in some how. Any thoughts? Thanks, adam

ok, will do. Thanks.

Thanks for all the help and inf everybody. Learned a lot.

  So I figured out what I was doing wrong. I finally checked the hertz with a real gauge and I was getting around 75 at full throttle. Seemed like I had to back the throttle down quit a bit to get down to 63 H or so. To bad there's no tack.

ok, that makes scene. but it does the same thing on single phase

Just watched the video. Very helpful. I will up load pic of what I have. Thanks.

ok that makes sense. thanks.

Hi, has any body used a gen synchronizer? I want to hook two 10 kw gens to it. I know I will get 20 kw but will I be able to get 440 volt 3 phase? Thanks, adam

No, everything still works fine.

thanks triple jim and r racing. good info

I have been doing electrical work for years. Always at code. I know what I'm doing. Amps, volts, watts. It's not rocket science. I was a builder for 15 years. The problem is I'm getting 120 on each lug. 240 into panel. The heat pump compressor works fine but the fan does not kick in to push the...