Search results

A goat has been on list list for a while. I may be able to get one in a few years. Gearz displayed one recently on the speed channel. Good luck with it

Finaaly got time to look at it this afternoon. I located a 10 AMP fuse blown. It was located at the botton of the fuse block. Now the Gen 2 light works and I have power at the volt meter. I still need a voltmeter. Thanks for all of the help.

That did it. That was a big help thanks.

thanks i will look closer

I have to remove the wiper switch from my m886. Does anyone know the correct way to remove the knob without breaking anything? Thanks

Has anyone had this problem before. My gen 2 light will not come on and the volt meter is not getting any voltage. I remember hearing something about a similar problem that was caused by a relay. Both alternators are charging. 1986 m1009

Thanks for the info. I have a new fuel pump on it. I now have the rocker arms removed and can hold pressure against the lifters using a push rod. There is no noticable movement. I dont think i have oil pressure yet but i think i should still feel the push rod move when i spin the engine over...

Does anyone know where i can get a set of piston rings for a mighty might. I have my engine partially built but need a set of rings to finish it. Is there anything comercially available that will work?

I finally got a few minutes to pull the timing gear cover off. The timing gear, key and shaft all turn. I also spoke with Bill Watson. He advised me that he has never seen a cam gear break. My next step is to pull the engine and start pulling it apart. My schedule it really tight but I...

Does it matter it the piston is at tdc or not when you remove the injector to fish out the end of the glow plug?

Thats great info thanks

I sent them an Email and they advised the Tool would be in stock this week. They were apparently out being case hardened. I would like a more economical solution. Especially this time of year.

The J20 I have beem getting parts from is located at Delks in Ashboro NC 1-366-629-0991. The j-20 still has both rear doors. They are in great shape. It also has the front sliding door. It is in great shape and complete.

I need help. I tried to start my mule and I have no compression. I put new jugs, pistons and heads on it last year but finally got around to trying to start it yesterday. I oiled everything up when i rebuilt it and soaked the lifters. I think they are hydrualic and at first I thought they...

Thanks I was trying to decide if I needed to get the engine out of the Jeep Ambulance, the ambulance body is shot with rust. I had a M715 but was very disappointed with it when i drove it, NO POWER. Can you advise what i would need to do for the small block chevy swap as far as engine mount and...

Can anyone advise if a 360 out of a j20 jeep will fit into a m715 without alot of modifications. Will trans bolt up. Will motor mounts bolt up, ect. Thanks fred

That looks way to cold for me. It was sunny and 56 degrees yesterday when i was working on my M886. Looks like a good project. Does yours have the litter racks. Mine had been removed. I lucked out and found the jeep version (J20 i think) The back books were locked so no one could remove the...

thanks for the info that will help

Just traded for 1 that by buddy restored. He mounted an armored IR light beside the head light. It came with the switch on the handlebar but the light itself had been remove. The armored light he added is mounted at a 90 degree angle and although it looks cool it shakes like crazy when you...

Does anyone have a picture of the IR light that goes on the front of the M1030.