Search results

It's not turning over slow it just takes longer than it did to fire.

Still like to figure out what is going on before it gets worse.

She started ok this morning at 6 am. Then this after noon at 4 pm she barely turned over one time and started like she always did before.

Yes I checked them with my ohm meter all but three.

I had to replace the mechanical fuel pump years ago because the check valve went bad allowing the fuel to drain back to the tank every time it was shut off.

Ok more info. I am still running everything stock. I installed a new set of ac delco 60g glow plugs. It has not been cold enough her in Northeast Maryland for the fuel to gel. The fuel filter I may changed back in the summer time. Thinking it might be the module under the dash. Don't know for...

Here lately been having problems with longer than normal start times. Replaced all the glow plugs and ends because they where bad. Now it takes longer crank time than it did before or starts. Yesterday drove 20 minutes home shut it off went in the house for about half hour or so went back out to...

Any one now the part number and where I could get a new oil fill / vent cap for my 86 M1009 6.2 lit diesel? Thanks.

Looking for two radio antenna mounts and brush gaurds for my m1009. Also looking for aantenna assembly to run my cb thru. Don't have my antenna part numbers handy to put on here right now.

Any one bringing some new style tarp bows for the m101 a2 trailer?

I had read them. Just had been a wile. Could not reminder. Thanks.

I thought it was 3 ohm

Thanks.

Where are the fuses? Close to the relay?

Volt gauge not working. Replaced gauge and still not working. Help please.

I know this has been discussed before but could not Find it. Looking to replace the front and rear springs on my m1009 but can not remember the length of them. If anyone could tell me thanks.

Started my truck this morning, and after it started I pulled the light switch to turn on my running lights while I when back inside to let the truck warm up. But I pulled it out to far abd turns the headlights on so I quickly pushed it back in not to shine my head lights thru the neighbor's...

I am looking for 6 or so of the screws that hold the fiberglass side boards on the metal side post.

I did mean to say bendix. This was a new gear reduction starter, and had been doing this sence day one. Should have replaced it then. Also if the flex plate was missing teeth, I belive. if you could get it to catch when you cranked the truck when it came around to the bad spot the starter would...

Is there any other electrical problem, other than a bad starter solenoid that would cause the starter to just spine and not engage. It does this intermittently, it will go for weeks and not do it and then it will do it every other time and then back. My M1009 is all stock. Thanks.