Search results

Not to hijack, but has anybody used Heim joints to replace the rubber portions?

Will anybody be at the meet that can help install a pyro/boost gauge? I can do the electrical and in cab stuff before, just need help mounting sensors.

This may be a dumb question that will probably be answered with "lockers", but could you do a cutter system where you can brake the left or right side of the rear tandem independently of each other? I use a system like this on my sand rail to get around having and open rear end. I guess you...

Out of curiosity I wonder what it is as well. I am sure it varies too depending if it gets driven in a scene or is just backdrop.

Well if I build the manual air system All I would be doing to the truck is adding a assist cylinder. It would in turn be manually operated by a switch on the shifter, so no drag link valve needed. I would also have another switch to disable the system completely so there is no chance of an...

Well that is kind of disappointing. It sounds that you would need a much larger cylinder for it to be any good. I would not be using it while driving at speed so the over steer thing would not be an issue for me. That's the Waterloo one? I have looked at his system but it says it's not...

I have been wanting to add power steering to my deuce but only really feel the need for it at low speeds. I figure I can build a manual version of the AOM system where when not in use both sides of the cylinder are connected to atmosphere. You would have a little more drag when steering normally...

I hate the fact that it is called the master or accessory switch yet does neither.

Well I don't thing I will ever be able to look at my diffs the same way again.

I would think for on road use the flex would not be enough to worry about.

Combine the Co2 and stalling it with the clutch and you should be able to stop it really fast.

Installed LEDs. Headlights and a 54" light bar on the roof. Slowly getting ready for Haspin.

Oh, So they are strong enough to lift the hood themselves. Ill have to look into doing something similar.

How did the hood struts work out? I was thinking of doing something similar but instead using some pneumatic cylinders and a valve at the front of the truck to help lift the hood.

I don't think the Halon would be bad for the truck, but if you are in an enclosed space it WILL be bad for you.

I might be interested in the Geeps. :roll: Unfortunately, alot of that older brass used to be worth something, but with the newer plastic reproductions having better drive trains and detail they have drove down the value of the brass. Now if you have stuff that hasn't been reproduced and you...