Search results

Also, I didn't notice any color coming off on the rag or damage on the paint surface when using the cleanser.

After having the Behr paint job for 3 months, i noticed white streaks mostly in the flat black areas and only under horizontal surfaces. All on the sides of the bed and tailgate, none on the cab or hood tops or sides. Washed the truck for the Christmas Parade and I had to use a little Bon-Ami...

Ground for parking brake circuit switch is at parking brake handle base

Failsafe module is grounded right at module with wire from multi conductor plug.

No problemo, living in California I'm always asking my wife "is this legal?" when I have a burrito with a piece of pizza or put hot sauce on popcorn. Good luck on your venture.

Whoa, it's a joke son. Your presentation is far superior to anything expected out of an old smelly (yes, all the deuce cabs have a particular smell), oily, probably rusty truck that served all those that served. My fondness for military vehicles and food would be a natural and I'd line up for...

Here is the schematic for the failsafe system. Test your switches, if they perform as they should then wiring or failsafe module is at fault. I redid the ground at the module and was fixed it for a short time. Replaced the module and all is good

You know, it's not legal to serve food in that presentation from the back of an old army truck

Started right up after 3 days - yahoo New failsafe module and I've got 2 lights again- yahoo

Painted the M923A1, then after reading a post about front spring hanger nuts being loose - tightened some of those. Well the fuel line from the filter to injector pump saw me pay attention to the spring hanger bolts and started to leak. I had been fighting a loss of prime for a while. I resealed...

Found several on mine loose. Thanks for sharing this

BehrPaint Job Well, after going back and forth between carc and Behr, I went with the Behr. I had done two deuces with carc from Rapco and was happy with the paint and color (1 - tan, 1 forest green). I tested a spray can of the 383 green from Rapco and didn't like the limey color compared to...

I hope you know you can't go through the car wash with that. I want one.

Our M923A1 has been reading a little high lately at times on the speedometer for the actual speed. Knowing how the speedometer operates I figured that there was dust, rust or oil between magnet and speed cup. Finally the speedo quit with the needle at 8:00 position. The back of the speedo and...

Sorry to hear of you and truck's issues. Our 5 ton started acting the same, starter would not attempt to start truck. I traced the issue to the starter control box and started to remove the box. I found the bolt with the ground strap holding the box to the firewall loose. Tightened it and has...

Look up BIT program, good luck.

Wait a minute, you mean we have 24 valves ? Shazam !

I had to have the CHP do the inspection of our M923A1 without title for the DMV after purchase from GL. He saw the engine label of 1983 and said it's a 1984 vehicle. I pointed out the transfer case and transmission with late 1984 build dates, but he didn't care. So I requested the SF-97 as 1985...

Good advice So Far Caution and knowledge the key words to use in avoiding the 100 lbs of spring in a 5 lb can

If you decide to go ahead at some point, please look into the Ca rules for commercial vehicles. If you want to put anything in the bed of the truck you must register commercial, meaning yearly commercial fees ($700 up), commercial insurance (our is $720/year, we had to get it for our 5 ton with...