Search results

I did the same as Floridianson and have had no problems.

Try a little air tool oil in it and try and help it to get going.

Then to turn it 180° Loosen the pump back it off the gears turning the engine 360° till the PC Mark comes up again and install your pump and try it at that point

Well he is mostly right. If it doesn't fall in the slot when you line up the The PC marks Turn it another 360° and see if it falls into the slot on the PC Mark again that would mean that your 180° out of time. Remember the camshaft turns at half the speed of the crankshaft so that's why you turn...

My injector timing was off 180* and it would just for a few minutes then slowly die off. Restart run for a minute or two then die off again. Does your valve cover get really hot in the couple minutes it runs?

Man I love that truck!!! Keep up the good work.

I still think it's in the clutch lever. Try moving it while someone is pushing on the control cable to wind it in or out and see if it engages

Did you move the clutch lever to the engaged position on the back side of the winch?

I will get some pics of my wheel bearing setup as soon as the weather clears up a little.

For the bearing design on my tire davit I use 2 Chevy 1500 4wd wheel bearing assemblies. They are 7 inch flange which is the same as the davit and I cut the flange off one bearing and welded it to the back of the other and drilled it to fit the bolt pattern. I got the bearings free from when we...

I mounted a bearing between the upper and lower davit on my m931a2 and have used it to lift a mt654 trans and my Mep-002a in and out of the bed. Yes it bows some but has never failed.

Will these work on the a2 models with the ctis?

I hope this goes well, I would like a set for my truck.

I am the one who has the winch in James Creek. Delta is about 3 1/2 hours from me.

Sounds good thanks.

I could meet you by chambersburg along 81 it's right before you get into Maryland. But it has to be on a weekend because I work 8-5 all week.

Ron if it's on a weekend I can meet someone within and hour or 2 of James Creek to get it heading your direction.

Try pushing on your brake pedal slightly and see if it quits. Mine was the treadle valve assembly.

No got it in New York. $450 I couldn't pass it up.

Just an older IMT 215. It's more of a tire service crane 15ft reach and 3000lbs max lift. I just wanted something smaller to load the bed.