Search results

Making sure wheel is straight Take a tape measure and a second person have the other person hold tape in the center of the front hub and check distance to the rear wheel center or leading edge of wheel ( just be sure to use same spots on other side )then compare to the other side will give you...

As stated either will work! I would use a synthetic oil !

Nice looking truck!

I think the camo looks better then the one color just my thought!

:ditto: You can never get to many spare parts! also remember they have not built these for awhile, Parts are not always going to be available and those with parts trucks will be the only source!!

Don't know how many times I'v seen it on here! if you keep the 24 volt make the swap on the top of list! its not if but when it will fail! why wait? :beer:

sounds cool ! get some pics!

Very nice! :beer: clean and simple!

You say you have the brake lite switch out. Is it still plugged in ? when you push the plunger on the switch while its plugged in does the lites go out? sounds as if you have a burnt together wire. the circuit goes from brake lite switch to the turn signal switch then to the tail lites. If the...

I have a powerbuilt spindle nut set and the socket you need is part number 648477. You can search the part number to see the socket it is 2 1/2 " 4 lug . OTC also has one part number I think is OTC 7158 but not totally sure on that number.

I use motor oil mixed with diesel with no side affects ! new oil just put it in! ,used oil I run threw a filter then dump it in with diesel fuel. I run about a 60% diesel and 40% oil in the warmer mouths with no side affects I have a spin on fuel filter rated for 5 micron rating I change it...

To me $15 is well worth the time and money to replace something that was put in because its worked! Not because it was made to do the job! the factory part is really a ac relay and as any relay you put more of a load threw it then it was really meant to handle . Its not if it will fail but...

:ditto: its up under dash below the ash tray area you will see two bolt heads on bottom of dash remove them and the plate with relay will pull down!

If you want part numbers I use the kats brand block heaters part number 11612 any parts store should be able to get them or you can get on line they work nice and have a replaceable cord put them in the center freeze plug hole real easy!

Get block heater and make sure glow plugs are good and working and will start fine! I plug mine in about 1/2 hour and cycle glow plugs and always starts [thumbzup]

After the wife drove one I can't be without 1 at least! She loves to drive them in her words " the idiots stay out of her way " It helps she is a country girl! And yes I am afraid of my wife at times. when she mumbles things like you have to go to sleep sometime! makes you think ? What is she...

Wait and see if anything is not working then you wil know! may have got lucky! [thumbzup]

May be the new fuel pump is bad! it is man made! and have seen alot of new parts bad!

I like the 5 gal can idea! come off the lift pump pickup into fuel can purge and see if it runs on, if so find your leaking between tank and pump! your sucking air somewhere! all it takes is a loose connection when you crank it pumps fuel when it starts the suction is a bit better and will suck...

At least it all good now! thats what matters! [thumbzup]