Search results

Ok I have a tester.for compression for a car or truck not small engine. As far a primer I've done it before starting never during the starting process. This gen ran before I started to tune it up. This is why I'm sob confused

MEP-016B running out of options, Need help bad! Ok i have a gen unit i put alot of time and money into, New starter, Fresh oil, fresh fuel, New filters, Both fuel and oil. Had the injector tested and works great. Tryed to bleed the fuel for ABOUT 15 MIN. Also tryed with starter fluid and get...

:(sadly can not find a shopin the area that can handle the gen unit.

mep=016b help needed in pa Need a kind hearted person to try and give me a hand. Trying to get help to try and get my gen unit to work the MEP-016B. Ive been loosing my mind trying to get running again, You can see my old posts on what was done. And even with other repair shops noone seems be...

Investor was tested as good. Pump I have no idea?

Anyone think there could be a collapsed line that is causing issues?

Nothing in the air box to stop it from breathing. Injector was tested and is good. The ip im not sure how to test. There has to be something that isn't getting enough fuel pressure. Tank is very full. Oil is full and fuel filter is new

Well injector works. Got a line to test the injector and it wont spray.. checked the Tm's and don't know where to start. There isn't a section for if this works but still wont start try this.

O whell guess not

Well finaly got time to take out the injector. That thing was covered with carbon. Now just need to get it tested and if needed fixed.

Ok for the helicopter sound effects they are sounding as if is down low. And the lower section is seen moving. Which is why I'm asking if there are factory brackets?

Ok strange question, but I can't find a answer anywhere. Is there supposed to be any type of supports under my m1009's dash? It sonds like a helicopter inside.

Mep016b

Thanks I had mine rebuilt. Still have a bunch of the extra parts that are still good in a box.

is the gauge 2" or 2" 1/16?

Found them on ebay at a cheap price also

Wgen I was down in nj we did a lot and the only other option is that the guage is not readin correct. Its reading but not showing what it should.

Any resistor added on it? Or just strait the way ment to go on?

Not seeing anything from them for 24 volt :confused:

Ok thanks again. Will see what I can find