Search results

Mgil, pm sent

i build custom m715 rims. 16 & 16.5" 8 &10" wide. stock centers and new tubless rims. can even powder coat them 4 you. been doing this for 25+ yrs bob

I have a bunch of 4&6 bt engines. I use them in m715 swaps aalso i remanufacture them for people. I bought 35 at 1 time a while back. Now i,am down to like 8-10 of them. They dont last long

Got a little more work done, 2 coats of primer, 24hrs drying time then 2 coats of flat black. Gonna refurb the 2 power locks monday. Will have detailed pic,s of p/l's very soon. Got the clutch packs soaking in friction modifyer now as dana recomends. Bob P/S LIKE 2 OF MY PUPS ? BLACK ONE IS...

Fellas, the m715 dana 70 axle is danas first design in the 70 series and the carrier along with the ring and pinion gears are specific to this design 70 series. It takes a 1/2" or .500 offset carrier and ring + pinion gears. The newer dana 70 axles all use a 5/8" or .625 offset carrier and ring...

m715 axles rebuild & d70 'correct" power lock THOUGHT you fellas might like to see a correct (.500 or 1/2" offset) m715 dana spicer 70 series power lock 23 spline ( 2 piece axle gears) . these things are extreamly rare. they havent been made in over 20 yrs and there is no parts left for them...

A.b. Linn in salisbury, n.c probably has them also memphis equipment, vintage power wagons also. Bob

If the gate is warped dont waste your time on it as it will never close correctly. There very flimsey from the factory. Thats why i make mine from double thick material.

need a new carb kit ? i have 1 and its new not n.o.s. and correct for the M715 holley 1920 bob

Thanks kwai , long time no talk pal. Hope all is good in tx. Tell everybody i said hi. Regards bob

About 5 minutes of loud detroit diesel and it will get your goat...... Lol got ear muffs??????? Bob

10-4 enjoy

You wont believe where all the soupy muddy grit gets to and you just think it off. Pull a brake drum for example and you,ll see, lift a tie rod end rubber boot etc.

Asked him about the clutch setup and all he would tell me was its a standard sae#3 13" clutch, pressure plate & flywheel. He said he'd rather not go any further as it will be part of the "kit" he is going to market. Sorry i tried bob

just cant see the point in going thru big mud holes. guess I,am getting old.

he custom builds the 3053a & np205 married setups and will build you a setup if you have the $$$$$

heres some pic's

He works out of town setting up and repairing printing machines. He goes to germany alot with his work. He told me he has 25k in it so far. Pic,s soon bob

I wish you fellas could see my pals m37 build. he,s a machineist and it shows. heres a list of the modifications. i,ll try to get some pictures for you fellas 4bta cummins diesel/ 130 hp stock dana spicer 3053a trans with .69 o.d. gear set & pto. "married" np205 transfer case 4 wheel...

I have about anything for a m715 except sheet metal. Best to call me bob 1-423-384-8938