Search results

Yes. It looks like it's going up for sale!

The only information I can find is on the directions and diagram on the inside of the lid. I have looked for a manual but havnt been able to find one yet

Will this one work for my MEP? I'm not looking to do lot of load testing just trying to check a few things on my MEP. I love the design and the portability of it but will part ways with it if it wont work with my setup. Thanks Bernard

What are the civilian load banks going for?

The gov took it back after you paid for it? Have you picked it up? Will it work with a Mep 005a? What did you pay for yours? I paid right at 400 with the taxes and fees. Thanks Bernard

It says. 1. General. The dunny load is designed to perform electrical loading tests on power plants rated either 28 volts or 120/208, 3 phase, 4 wire, 400 cycle A.C.. Both Dummy load systems (A.C. and D.C.) may be operated individually or simultaneously without influencing each other's loading...

Any tips and tricks for testing out my Mep 005a with my newly acquired load bank

Thanks for all the info everyone!!

Premixed or do you mix it 50/50?

Good morning everyone. What type of coolant and what strength is everyone using for their Meps? Thanks Bernard

Did you ever get the genny back producing power?

I really appreciate the help guys!! Is it difficult to install? Can it be installed without removing the gen end of the genset?Thanks Bernard

I was wondering if anyone had any info on the "carrier bearing located at the end of genny near the cooling louvers and control cubicle? It's shown in the tm-34 page 295 figure 5-36 #22 carrier/housing and #23 is the actual bearing. I start my genset up about once a month and apply about a 50%...

Part came in. Installed it and guess What? Everything is working just as it should. Hertz meter is reading 60 where I had the throttle adjusted at, and voltage is reading correct. Thanks for all your help Guyfang and I hope others will find this post helpful. If anyone has to replace the thermal...

I found one on ebay b4and new for $139.00. It is the new NSN 6625-01-180-7579 (part number 69-589). I have started reading the TM and will replace the static exciter if necessary when I cross that bridge. Again I really appreciate all your help and will keep you posted on the progress of the...

I really appreciate your help. You well know and we'll respected on here. On last question. What is oozing out thermal watt converter? Why did It do that old age? Thanks

No idiot lights. I did test them by the test switch. All working properly

Ok. Started it up. Let off S1 after it started and flipped S2. Still no change in volts (went to 0 volts as soon as I let off S1 same with hertz meter). No wiring diagram on any of the doors I did download all the TMs when I got it

Sorry I'm new to these gensets. By s7 you talking about the battle short?