Search results

An interesting read! I didn't think I'd finish it, but it drew me in. Thanks for sharing. BDGR

Can't say I've ever noticed something like that in mine, so I'd say it's not planned. BDGR

Thanks CARMAN. I’ll reach out to them. Bulldogger

Thanks friend! Hope to hear good news today. BDGR

Or you could pour naval jelly in and wipe it ouT. Then after clean and rinse according to directions for the jelly, hand brush a fuel and rust resistant paint? Lots of answers. The spray and wait stuff, in my experience, never meets the expectations given on the can... lots if ways to skin that...

Greetings All! I'm looking for a reputable shop in Northern VA or DC Metro to handle a re-power of my HMMWV. I'm planning to purchase a 6.5NA or Turbo and 4 speed drivetrain (trans and transfer) soon. I'm prepared financially, and now that I have $$ to invest in it, I'm ready to speak with...

I guess I got lucky wanting OD Green. BDGR

It was just over a month. I was thinking it was time to email, having politely waited a bit, and when I emailed they replied in two days with a tracking number. BDGR

Good looking passel. BDGR

Got Baby a new hat, er, I mean I installed a new Soft Top from Breton Ind. Looks great. Wasn't near as hard as I'd expected to reuse the front pillar bracket. BDGR

Woof!

That is pretty slick 3jacks. Folks will be asking you to make them one, if they haven't already! BDGR

+1 for sigo's comments about replicas and broken units for display, not hard to find and prices aren't horrible. sigo, I'm using a Clansman PRC-352 purchased off ta_shunca_uitco off eBay. It's a manpack, so I had to make a bracket to hold it in the HMMWV. I did buy his vehicle mounting...

I use a Clansman, surplus from the UK. They are the least expensive options readily available, though not "period-correct". Also, incidentally the ARRL are not conducting FCC license testing at this time. So it's not possible to get a license at the moment. However, papakb's statement is...

Once done are you going to swap them side to side to the smooth portion of the rails faces outboard? Would look a little more polished that way. BDGR

Poop, but thanks JKDAY

Spinning opposite each other when turning one tire manually is normal. It sounds like a transfer case problem. Have you tried disconnecting the front propellor (i.e. drive shaft)? If the T-case output yoke doesn't turn when the propellor is disconnected and engine running/in gear, the T-case...

Anybody know a source for Mirror Lite? They only list school bus distributors on their website. I’ll email them I suppose, if no one knows a good source. Bulldogger

Nope, not as far as I've ever seen. BDGR

That part number turns up the same rounded corner ones. Does this mean that the square ones are particular to a single source/manufacturer? BDGR