Search results

Before you cry, see if this is a head gasket rather than a cracked head. If gasket, replacement isn’t joyful BUT it is a lot cheaper.

I honestly don’t understand where this is going. I don’t see a diagnosis yet. I don’t understand what everyone’s talking about battery chargers. If this gentleman is able to turn the engine by hand for several revolutions, in my mind that goes against Hydro lock because Hydro lock would not...

Monroe Magnums, because for some of us on Steel Soldiers, only a Magnum is big enough to fit.

Thank you one and all!

Rico Suave Rhino installed and ready for grease.

What would you use instead Steve? and thank you

Small leak bottom of fuel cell. RTV curing SLOWLY. Might replace with self tapping screw and rubber and RTV as a gasket. New Rico Rhino spare tire carrier about to be installed. Tire day so all muscles gating a workout. Just 4 more to go.

Don’t need a gym day when u r doing wheels w/runflats. And a big thanks to Dustin at Feltz Tires.

Driveshaft will be done Wednesday. Batteries are out. They are all from 2020. Two so far are taking charge. Two have not been connected to the charger yet. I will use them to get things started and then look at new batteries when she is roadworthy. Shocks just arrived. Gonna see about...

You discussed the same questions in that other Hummer Forum IIRC. As much as I love Will L,, he pushes things like FASS and Leroy harmonic balancer/ gear timing equipment, potentially harder than they need to be pushed.

You want to plan replacing a harmonic balancer that literally almost no-one does… before talking about fluid changes on hubs, transmission, X-fer case, engine, power steering, brakes, fuel system…and discussing EESS vulnerability, replacing ball joints, control arm bushings, tie rod ends…...

Shift into neutral and see if it cranks. Shifter switch may be fried. Go behind dash and check start switch wires. Run a hot wire to the solenoid and see if it engages or is fried. Check wire from PCB to starter/solenoid and see if it is energizing.

$610 clams to retube the driveshaft. I’d love to find the fork lift operator and give him the bill. Cold today. Gonna concentrate on work on the trail M1165

Tylenol??? Please fix your spellchecker. I think you misspelled ETHANOL.

PM sent to OP

Rear axle out. In the process of being re-tubed. That recommended U-joint tool did great GeneralD. Many thanks! Front axle has forklift damage too. So do BOTH rear shocks. I’m assured that the forklift operator was careful and used both his cane and his seeing eye dog. 😖 Purchased a turret...

Welcome BUT nopics

Torn hose. Loose fitting. Broken valve? Soapy water and spray gun and isolate leak and post pictures.

What type of vehicle? If you have a 6.2 engine, the harmonic balancer has a nasty habit of getting loose and you start shaking like crazy. Edit-seems like your sig line states 2004 M1123… If you’re harmonic, balancer itself has gone bad, that can also cause shaking. That is in addition to...

N/a Diesel hates elevation. Supercharged Diesel does ok. IIRC, FMTV are all turbo.