Search results

Please educate this newbie on preferred electric alternatives. I actually like electric. Which or what winch and best attachment sites and methods. And many thanks.

Many thanks… wish I had a PTO

Thanks. Ordered.

I guess I need a drive shaft removal primer. Besides removing the zirk fittings: What tools do I need to press the joints out, and… What tools do I need to pop the caps back on after the repair and balance?

The dashboard wait light only tells you you activate it. My light tells you whether or not you have any functional glow plugs

I will go with Monroe 65456 at least for the short run. I understand the limitations. There is an axle shoppe that will repair and balance front and rear driveshafts. The place is 15 miles from the truck. Not bad. I will use 3mm thick cold roll to make the turret cap. Plasma cutter and drill...

I’m not afraid to customize. Where can I find the replacement options?

My rig has a bent shock from a forking forklift at GovPlanet facility. Same with drive shaft and tie rod

All great suggestions and viewpoints. Many thanks. What about shock absorber alternatives?

Truck axle place within 15 miles so gonna remove rear drive shaft and get her retubed and balanced. Any idea what shocks can be substituted and swapped into these rigs that don’t break the bank?

I did some research on the interweb and made contact with this gentleman. M1043 A2. 2001??? He has owned it since 2019 and has driven a few 1000 miles. Currently, he loses power and gets black smoke at speed. He has swapped out a new fuel pump BUT didn’t know the trick to keep the pushrod up...

Read my sig line for DIY PCB/EESS box instructions. Lots of happy rebuilders.

Great video for me (the current newbie) to learn from. MANY THANKS!

So… ideas on where to start? I’m thinking getting the rig to turn over. What do I need to worry about with the IP? Common no-start issues after J-6 fuel fudges everything up? I’ll check the fluids first and then remove the rear driveshaft. I’m told the tires still hold air so I will blow off...

All my VIN# 250000+ ECVs that were demilled at GovPlanet have a 14 degree bend.

Start by turning things “on” and using a voltmeter to detect current at the three terminated plugs. If no, see if there is current to the box. You may have already done this. Not sure from your posts

Just buying parts and throwing parts at your truck without understanding the complete system is dangerous and expensive. You should always know what you’re purchasing. Those boxes work with a special windshield IIRC. IIRC that windshield contains special tungsten filaments between the panes...

So far he has not responded.

I PM’ed him. He is near me. I will see if I can help.

They sell heated ballistic windshields. Check some of the vendors.