• Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!

  • Microsoft MSN, Live, Hotmail, Outlook email users may not be receiving emails. We are working to resolve this issue. Please add support@steelsoldiers.com to your trusted contacts.

Search results

  1. N

    mep-831a suspected K8 relay fault

    Hi Kurt, since these inverters are generally so sensitive, what about instead of trying to improve or fix the current design, a low frequency transformer design was utilized instead and the current inverter ditched? I guess looking at the space there isn't enough room. It would also be expensive.
  2. N

    803a not warming up

    My apologies, The gauge reads zero, I need to fix it. I've been measuring temperature on top rad hose both with IR and I have kurts remote start installed and top rad house and readout in kurts device are same-same. +- I saved the original thermostat, I'll go boil it. This generator I ran...
  3. N

    803a not warming up

    Good evening, I have an 803a that is not warming up With ambient around 21 F, it warms to 145-150 degrees. There is some wind. I have covered the air intake facing the wind with a some plywood, 90% coverage. I have covered the exhaust 80% again with some plywood. Temp is now up to 165F Any...
  4. N

    MEP-804B - New to me, I have a few questions

    What are the specifications on your solar / charger system? I see what looks like a outback 60 amp and an outback 80 amp solar charge controller. What are the details on the ac input to charge the batteries? The photo you posted is not that clear. Do you have manuals or specifications on the...
  5. N

    Saving deeply discharged Optima 51R's

    I have used supply mode on the noco 7200 for 12-20 hours, followed by pressing and holding the mode button while in supply mode to access 'boost' mode which is IIRC 16v at 0.5 amp and then 24-30 hours to completely bring the optima back.
  6. N

    First MEP , fixed shaking Oil Pressure senor mounts and other mods

    More race parts! Looking good.
  7. N

    MILITARY TACTICAL HEATER 35,000 BTU SELFPOWERED, (MTH35SP

    There must be a whole warehouse somewhere full of accessory bags for these units... or at the 16k $ per piece maybe they were not widely used or bought like previous versions?
  8. N

    MILITARY TACTICAL HEATER 35,000 BTU SELFPOWERED, (MTH35SP

    There are another two up for sale now, again without controllers.
  9. N

    MILITARY TACTICAL HEATER 35,000 BTU SELFPOWERED, (MTH35SP

    Hi Guy, all the parts are off the shelf for the unit EXCEPT the controller which you have to buy from MDT for big $$. I may be better off to hunt for a second same unit on auction WITH a controller and then copy it. But I don't really need two.
  10. N

    First MEP , fixed shaking Oil Pressure senor mounts and other mods

    I like the race parts upgrades (anything aluminum anodized colors fall in this category for me)
  11. N

    MILITARY TACTICAL HEATER 35,000 BTU SELFPOWERED, (MTH35SP

    Hello gentlemen, I have a once used HDT MTH35SP (manual here ) without a remote controller and thus no way to start or run the heater. I've search and found a threat in this forum on rebuilding the battery. Would anyone be willing to open their controller and take photos of inside so I can...
  12. N

    MEP 803a with Mil Trailer

    What were the part numbers and where did you source the mod parts from?
  13. N

    Got installed on the island - MEP-803a

    Maybe buying more generators is not the solution, but maybe it is? Your 803a directly powering the airconditioning and another 803a and or an 802 (not sure about your other loads) powering the main panel. Then you have more robustness potentiality. How nice is your place in bahamas - maybe...
  14. N

    MEP 804A filters

    Hello - did you find out these all fit? I've cross referenced prices and part numbers with napa: oil filter napa 1330 $20.53 fuel filter in can napa 600063 $10.17 15 (14) micron fuel filter napa 3472 $17.36 air filter big napa 2489 $33.89 air filter small napa 6517 $27.50 Nate
  15. N

    MEP 803a fuel filter housing (spin on)

    Hello gents I have a mep803a that is missing the larger spin-on fuel filter/water separator. I am looking for recommendations on what to replace the spin on filter housing with, my generators one is missing. I would also be interested in buying the housing and the fittings if someone has...
  16. N

    MEP-803s and UPS loads

    I’ve sent you a pm Thanks for all the info Sent from my iPhone using Tapatalk
  17. N

    MEP-802/803/831 Generator Control & Parameter Monitor by WIFI Demo

    I’d be interested in helping test Sent from my iPhone using Tapatalk
  18. N

    MEP-803s and UPS loads

    I am looking for a single phase 240v 4-6 kva double conversion true online with bad or no batteries I can put back in operation (run whole house on it) can you recommend any makes or models you see online ? Sent from my iPhone using Tapatalk
  19. N

    MEP-802/803/831 Generator Control & Parameter Monitor by WIFI Demo

    Count me in for some! Would also like a replacement battery charger for the 24v battery (maybe also a bench capable module with 110v input ) Regarding the remove monitor and auto start - I would like to see how this could be triggered by a low voltage signal to start and charge the battery of a...
  20. N

    Wiring a 50 amp 120v rv service

    Just a question on ground : you have it going to your trailer but also a grounding rod at generator ? I’m guessing trailer has no grounding? Sent from my iPhone using Tapatalk
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website like our supporting vendors. Their ads help keep Steel Soldiers going. Please consider disabling your ad blockers for the site. Thanks!

I've Disabled AdBlock
No Thanks