Search results

Also belt does not move when turning.

The nut is still tight. I did notice that the nut/alternator spin freely in one direction. When I try to spin in the other it does not. Not sure if that is how it is supposed to work?

So this is what I used to fill my holes in the truck. I used approximately 50 stainless M10x30MM bolts and nuts. https://www.amazon.com/gp/aw/d/B0D7YTQKQL?psc=1&ref=ppx_pop_mob_b_asin_image These are 10 packs with nut bolt washer and lock washer. In addition I used rubber washers to keep the...

I’ll take some pictures when I get out of work.

No torque wrench. Just tightening it down as hard as I can.

I will have to take a look. I could see how that would cause the nut to loosen up.

That is a good idea! I think there is. I will be looking into this idea.

Than you for the picture. It is not the Vbelt style pulley. It has the belt style. And the nut is a large flange type.

Not sure if there is any kind of lock washer or something that I’m missing. I only put on the large flange bolt on.

I put red on there.

I keep having this reoccurring problem of my alternator pulley nut falling off. Not sure if anyone has the same problem. I put it on tight this time with some lock tight. See if it works

Took out the water valve and replaced it with a normally open ball valve. Toggled to A/C on valve closes. Turn off/heat on valve automatically opens. Works great, no more hot water getting in while AC is on.

I’m going to be replacing my pitman arm soon but unsure about the locking tab system that’s on there. Also what size pitman arm puller to buy. M1152A1

Where do you park it? How long does it sit between starting up. Could be moisture/condensation building up in exhaust. Or somthing burning off that gets in there?

If you are doing the hubs I would open the inspection cover and try to clean out any sludge that has built up. I replaced the gear oil and shortly after had to do a seal. I drained the new gear oil and it was all discolored from the sludge on the bottom.

I notice while driving that there seems to be some play/wondering in the steering. I jacked it up and started moving/pulling things. I noticed some play in the idler arm and a small amount of movement on the pitman arm at the ball joint. pictures of movement attached

Mrfarb where does your drain line exit the body? I did not have any hose attached when I got the truck.

Attempted to take apart today. I got some of it apart but I think I would have to take the whole unit out to get it apart. I put it back together after determining that it was a bad idea to try to get it apart. i ended up blowing air through the drain hole. Then I stuck a garden hose through...

Thank you

I’m in need of a diagram/pictures or possibly a tm for my AC unit in my M1152A1. The AC evaporator area seems to be clogged and I have condensation coming from everywhere and water on the floor. The water that does somewhat drip out the drain is really dirty. Also when I turn I can hear what...