Search results

Dang it Bob and Dave, now my secret hmmwv supply is out. Back to CL and Ebay! They buzzed my house in a pattern most of yesterday till just before midnight. Each chopper landed one in my field, left the hmmwv. Taped to the window was a SF97 form filled out in my name! lol Anyway, training is...

Either one works. Heavy ones are the newer version as the hwwmv got fat.

G503...M1038 Arrives page 5 shows a picture of the L bracket attached to the rack.

Economist, Rear cross member uses the same pivot bracket for both setups. The only differences are the L Shaped brackets are relocated and new brackets need to be added between the rack and latches. I have pictures but not with me. On the g503, there is a picture I post a while back of the...

diverman555, I sent you a pm yesterday... Personally I would not sit in any hmmwv and have someone get an itchy trigger finger, think aluminum. I do have a couple of M1045 Slant Backs with supplemental armor installed and 5/8" glass. PM me if you want to setup a time. Thanks. PS: I drove a...

OR make a trip to Lansing MI and look over my inventory. Buy them complete with title and then do what you want to it. Way more fun and less money.

Thanks Steel Soldiers website for the helpful classifieds! I just sold my last deuce (M185A3) and about 2 months ago, I sold the other M35A2C! No other site provided me the hits on my ad than SS! PS. I donated $50 to site. :-) Regards,

Chris, Make sure your filter bowl is full of fuel. An easy way to remove the air in the supply system is to put a suction device on the outlet of the filter and pull a vacuum until you have a constant supply of fuel. I use a siphone tube for this. Other problematic areas: the check valve in...

I have delt with several shipping companys when trying to move my M185A3 and have found the following: Shipping a deuce van truck can be expensive because of the overall height and it requires a lowboy type trailer ($$$$). A drop deck type trailer sits too high unless you remove the tires/rims...

Here is an original 3 color camo M1038 just prior to being painted. Hope it helps.

The IP solenoid requires 24vdc to allow fuel to flow.

Thanks everyone who set this up! I had a great time and had a good shake down test drive with the hmmwv.

Does this truck have the fork truck damage on drivers side? If so, then assume the drive shaft is bent and will need to be dropped anyway.

If things go as planned, I might be able to attend!!! I'll bring up hmmwv that needs to have its shake down drive/test!

Here is some more pictures of other trucks in the yard...

Chris, I do not really have pictures but the manual has good figures. Plus it is difficult to expain. See below. For the DWF kit, here is the complete installation instructions for it with drawing (thanks to the hummerknowledgebase)! Deep Water Fording Kit - Installation BTW: everyone...

Chris, That is the standard engine ground and needs to be there. The MWO grounding harness is addtional and allows all electrical components to be on the same ground plane. Pictures of a 6.2 I just installed...

Nice! I'll pull a fan clutch tonight. While the stack is out, its a good time to service the front brakes, brake lines and vent lines (if needed). Another item to consider replacing is the front crank oil seal. I am doing that now on a fairly new engine that has been sitting (easier to get...

Awesome work Chris! That's how I like to go! Fyi the torque converter slips out with the engine if you pull the engine forward while lifting. Anyhow, I have a few fan clutches. On the motor mounts, did you loosen the 3/4" nuts so the brackets could move? This makes bolting to the block easier.

Welcome! Need some parts let me know.