Search results

My issue is getting into the fall season our Vehicle club has a lot of events, Parades and other stuff going through November. I am in agreement that I don't want to be in a park full of kids on ATV's. Maybe we should try and plan on a event next spring say in April? Don't know just a thought...

Being that time is getting closer, for those of us that have cell phones do we want to PM somebody close (Jason) with our phone numbers so that if you have a breakdown you could let people know that you will be late or not at all, Just a thought.

Wil here you go.

Ok maybe mine is special Because there outer grease seals just like there are on the rear. If they don't belong that could be the problem. I just look at the TM and it does not show the outer seal on the front But when I disassembled it they were on both front wheels.

Ok as stated in my early post I had 2 hubs that were hotter that the rest. Today I jacked up the front and spun the hot side and there was a noticeable drag, I removed the hub (these are the de-splinded hubs) and the wheel spun freely. There were no ware marks on the splines. I marked the hub...

And counting :lol:

Well I finally finished re-packing bearings and changing all filters , topping off all gear boxes and a full grease job on all the grease zerks. I went for a test drive the new De-splined hubs are great, and after a drive of almost 10 miles I stopped and checked for leaks and hot hubs. The...

I there a small amount of voltage getting to the starter causing it to heat up ?. Then the heat causing the rust. A bad connection? And isn't there a gasket that goes between the starter and bell housing? May be none of these but worth checking.

I do the same, I added a ring to my trailer and pull it with my Duce. I can also still pull it with my pickup truck, added a set of 24 volts lights as well as the 12 volts.

Got mine from Will the other day Have not installed them as of yet Most likely will put them on tomorrow. They look great.

Are there any good Eating joints close or is cooking over the fire in order

Will My brakes lights quit not long after I got the truck running had power to the switch just wasn't going through replaced it with the kit from Saturn it is now on the air side it works fine I left the old one in the hole it is just acting as a plug. When I wired trailer brakes up for the...

Re: RE: Re: RE: Packing bearings and checking Brakes That's good to know as I was going to ask that question. There was not a lot of grease on the rear bearings there were no rough spots or any discoloration. Thanks

OK I still plan on driving down on Friday Who else plans on being there Friday as well?

Re: RE: Packing bearings and checking Brakes Hey No problem I know that what its like to be busy. Glad to here that you got the "Package" Thanks

I started the process of Re-packing all the wheel bearings and checking and adjusting the brakes. I have done the front already just haven't installed the drive hubs as I hope put on the new de-splined hubs that I am getting from Will. The brake linings all looked new and needed only a slight...

Truck looks great What paint did you use?

Driving truck down pulling a trailer with my Jeep on it.

Yes Time is getting close, I steel plan on driving down on Friday along with Dave and Mark. I will see them this weekend to firm up plans. Its about a 3-3 1/2 hour drive for us. Also have we found out what the $$$$ will be?

While we are on the subject of Duce campers I saw this one in Alaska last week