• Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!

  • Microsoft MSN, Live, Hotmail, Outlook email users may not be receiving emails. We are working to resolve this issue. Please add support@steelsoldiers.com to your trusted contacts.

Search results

  1. 48cj2a

    Picked up my CUCV last night

    See firgure 153 of TM 9-2320-289-20P should be one in each corner and either side of the wheel wells.
  2. 48cj2a

    M1031 PTO Governor Control - Factory Technical Manual

    what is the market llike for the complete box/bed w/ gen and compressor? looking at a m1028a1 w/box this weekend. whats a 76k miles non-running truck worth ?
  3. 48cj2a

    M1008 urgent help needed

    Take the lockouts off and scuff them with sand paper and repaint them gloss black or OD. New Dana 60 premium Warn lockouts are not cheap.
  4. 48cj2a

    1985 CUCV engine help

    Don't know for sure but my guess would be night ops near a local boat launch area at the river. They have a thermal vision system in the service CUCV they are using.
  5. 48cj2a

    axle swap

    Is there any difference between the D60s width on the Dually version other than the reverse wheel adapter? (remove the adapter and would it be the same axle as the 1008?) Is there any difference between the 14bolt on the dually width wise? Is it narrower to add duals on each side?
  6. 48cj2a

    1985 CUCV engine help

    The detective I delt with said the engine ran but was rattling real bad. I did not pull the heads yet... There were only 2 tranny and the lower motor mount bolts holding it and nothing wiring wise so I thought for no more trouble than it is to pull plus give me a chance to inspect all the...
  7. 48cj2a

    1985 CUCV engine help

    Been lurking a little while and made a few posts to other threads but thought it was time to start my own thread. Purchased 1985 CUCV M1009 (Blazer) with 48K from my local Police Dept. They procured it from Ft Carson, CO so there is very little rust and it is in excellant condtion. They...
  8. 48cj2a

    M1009 floor mount mystery

    The previous years 73-at least 80 Civy Blazers seat did not slide and recline forward for rear passenger entry it actually hinged toward the windshield and the rear locked in the recess around that round stock. The jack also stores under the seat but uses a bracket welded to floor with a slot...
  9. 48cj2a

    Problems after lifting M1009 4 inches

    It is not uncommon for the drive shaft to turn on Chevy 73-87 and 88-91 K5s and Subs w/ hubs unlocked. A 4 degree taper shim between the springs and axle will also help a little on 4 - 6" lifts. In 1981 when the NP203 and NP205 began to be replaced with the NP208 most of the lift companies...
  10. 48cj2a

    38's on M1008= Better Gas Mileage?

    I can't see where raising a brick in the wind is going to hurt your gas mileage. These are not exactly aero dynamic to begin with. Your driving habits will effect the mileage more. I've had several GM trucks with 33" all the way up to 40" tires. Pick an all terrain tread 10.50 -12.50 and not a...
  11. 48cj2a

    willys help

    First - welcome to the world of the flat fender and I would like to invite you over to TheCJ2Apage.com everything about the Willys CJ2A Jeep there is a wealth of knowledge and information on our forum and like here experts with the CJ2A vehicles. You have a typical condition vehicle for its...
  12. 48cj2a

    According to Gov Liq...i dont exist? WTF?

    I work for the Govt and we do have our problems, but please do not confuse GL with being govt - they are not, just another low bidder contractor ripping you, I and the govt off.
  13. 48cj2a

    Hairba11's LED Headlight build (a.k.a. huffing solder fumes on a sunday afternoon)

    Very interesting project build. Can't wait to see how it turns out.
  14. 48cj2a

    Mosler, SAFE -FILING CABINET

    I can't quite make out the lock from the picture angle. Can you take an picture of the actual lock and one of the backside behind the panel. Since they are open all you need is patience if you have the change key, I have a few from upgrading locks to X0-7 series so if I know the model I could...
  15. 48cj2a

    CUCV gun trucks?

    The yellow and red paint is a Euro Requirement (Germany I think). The white box may be a roof A/C or cooling unit.
  16. 48cj2a

    I just won this trailer...Any ideas what it is for sure?

    It is a Fuel trailer with gas pwered pump. We had one in our MP in the early 80s until they installed an inground tank and pump for MOGAS A1B is a fuel trailer. Should have a canvas cover over the front to protect the little motor and such from the elements and yes it was towed by a duce.
  17. 48cj2a

    WWII 1/4 ton trailer

    I'm the keeper of batamt3c.com and just stumbled on your thread. Congrats on the ACM find! I'm about 99% sure you have a Bantam T3. Which is Grand Daddy to the T3-C Civilian Trailers. If your planning a resto you should have combat rims like these...
  18. 48cj2a

    scrapping a XM689 shelter dolly

    Nobody has a S280 or equivilant to tow behind their duce or 5 ton? I've spent many an afternoon installing or removing these at work. Even installed about a dozen kits on the shelters that were not mobilizer capable. Make a nice flat bed trailer platform too.
  19. 48cj2a

    another use of the m1008

    Remember National Lampoon's Vacation...don't forget to un-tie the dog when you leave!
  20. 48cj2a

    Trailer light wire identification

    M-SERIES VEHICLES CIRCUIT NUMBERS
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website like our supporting vendors. Their ads help keep Steel Soldiers going. Please consider disabling your ad blockers for the site. Thanks!

I've Disabled AdBlock
No Thanks