Search results

You can’t go wrong with Rapco 383 green. Look up black dog custom on Facebook. If you message them Michael will get back to you. He is a great guy.

The symptoms scream head gasket but I don’t know how you would roast a head gasket while spraying water

Today’s poser mod

I went through the same thing ordering parts for my last truck. They definitely did their due diligence. On a separate note a group of us from MIssissippi are going to convoy over to the USS Alabama for the Dixie Division and show and swap April 14 and 15. You should join us.

I actually just PM’d tomcata3 for that very picture. I will be sure to document everything as we go. I still have to get a the two hard lines on the front winch from mile marker before i can get started. GI Joe smoked them when they took it off.

Anyone have any experience with plumbing the rear winch setup on a hmmwv. I have the TM’s and for the life of me I don’t under how the controls work. I see that there is some kind of control that attached at the Cadillac valve. I am assuming that this controls which winch is receiving power...

That and I am convinced that somebody at the DOD has a brother in law at GM. There is no other way that they used some of this junk so long.

This week it’s been hack new parts up week. On my last truck I used the Those Military Guys upper console. It was nice but the construction left a lot to be desired. It was pretty flimsy and the welds were terrible on the tabs that hold it to the A pillar. I figured there had to be a better...

This week it’s been hack new parts up week. On my last truck I used the Those Military Guys upper console. It was nice but the construction left a lot to be desired. It was pretty flimsy and the welds were terrible on the tabs that hold it to the A pillar. I figured there had to be a better...

What’s the damage to the pocketbook? Sent from my iPhone using Tapatalk

Could you elaborate? Sent from my iPhone using Tapatalk

I have had great service out of the NOCO genius. It does 12v and 24v. They offer one up to 26 amps. I have the 7 amp version and put a slave end on one of the quick connects. It works great to throw on all my green gear. Swap to the clamps and it works on all my 12v stuff. NOCO Genius G7200...

And trucks with squirrel / rats nests in the blower. Sent from my iPhone using Tapatalk

First make sure your batteries have a GOOD charge. The cold may have killed one or both. If you don’t have a 24 volt charger pull the jumper between the two batteries and charge each for 24 hours minimum with a trickle charger. Clean all your connections and try again. If that doesn’t work pull...

There are lots of videos on YouTube. Watch as many as you can. Make sure that the torque converter is full of fluid and make sure that it is seated correctly against the pump before you install it. It’s not really a hard job. It can just be very messy. If you have a transmission jack that will...

Many people have added Jeep Wrangler rear seats to the back between the rear seats similar to the knee available with the H1’s. I would definitely bend up a cage around that if i did it. Make sure you have good frame attachment to your cage. You will also need to attach your seatbelt anchors...

Why not just go all 12 volt if you have gone this far. Basically all you need is a 12v heater blower and wiper motor now. You can swap all your bulbs to LED s Sent from my iPhone using Tapatalk

I can not help with the actual knowledge of that too but I can speak to Michael and Black Dog. They are good honest folks that do a good job. I have always been impressed with their service and the quality of their products. I have always had great dealings with them and their products are all...

I was talking about the tag being he best accessory. I got it registered and tagged. Sent from my iPhone using Tapatalk

I have a campout I forgot about with the nephew this weekend so I have been thrashing to get things reasonably ready. The steering wheel was chipped so I wrapped it with some para cord to hold me over until I can find a new style wheel. I also installed a “console”. It’s got chargers and...