Search results

So im looking for a subtank for my 803a and found this pic. Does anyone if this is actually a subtank, how many gallons it holds or perhaps a model number to get some specs on it.

Funny, i actually have same setup. My gantry crane with a hoist makes it a breeze. The pallet jack helps to slide. Another way would be an engine hoist. Either way its a 2 man job to avoid damaging the chasis and enclosure.

I had to swap engines today. I must say that installing the engine with the genhead on and sliding it in is by far easier than the old method of seperating the genhead from the engine while still bolted to the chasis. Luckily i had this one that came from gp auction in crate that was good. The...

Alright! Just got the 005a thermostat and gasket in from Oshkosh. Thermostat came w/o box and the gasket in original package just as pictured. Thermostat is a Motorad 195° with 0821 marking on the other side. Will install tommorow and get her on the load bank.

Actually I just submitted my order to oshkosh for the 005a thermostat and gasket. Lets see if I get original or napa. Will report back.

Howdy folks. Im having issues with the alternator on a 007b. Its the same used in 006a and 005a. It was not outputting any power so I had it rebuilt in a local shop. Reinstalled and no dice. Took it back and they showed me on a bench test that it was properly working. I believe its an excitation...

Im not going to connect the heater. Im in PR and its always hot. 😅 Thanks for the help, im trying to get this rig rolling.

Howdy. Im in the market for an air dryer for my lmtv. My unit came without the dryer so im out of commision for now. Skf brakemaster 2000 is preffered but ebay is all out. Anyone have a spare to sell?

Hello. Im looking for a parts manual for the 807a. My unit has a bad fuel level sender and the top part is rusted so model number is not visible. Anyone?

Howdy guys. I have an M1078a1 that I want to get running. I mainly fix gensets and dont have the time right now to dig into the lmtv manuals and do guesswork on the A1 stuff thats not on the manuals. Anyone want to come over to PR for a few days and help me. We can work out reasonable pay and...

Howdy boys. I am well and I have s1 switches in stock. 7875907103 is my number.

I have the battery disconnect switch. I always leave it off but still the same after switching it back on. Im thinking a bad tcm.

Howdy. My M1078a1 wont crank, bot even using the switches under the cab. The fuse panel has the k34 differential led on and my transmission controler is stuck in mode once I turn on the power switch. Im lost.

Is the wire that connects to the front left negative post number# 1650? I have another thats #1651, and dont know where it goes.

Thanks for the pic. It helps alot. I see a connection that i dont have. Does the back cable that connects both positives then connects to the front right positive post ? Like in this pic

Ok. I think i got the wiring right. The slave port now shows 24v. The generator has two alternating yellow lights. I have to wires in the pic below that i dont know where they go. The one with the terminal has 17vdc. Weird.

Yes, the only long cable that comes from under the cab is the ground.

Eaxtly. I have a long cable coming from the cabin side and 3 cables coming in from the disconnect box. I have seen plenty of vides and dont see what i have. Mine came without the cover so no diagram and i believe it was missing 2 of the positive to negative cables. I managed to get 12v and the...