Search results

I know the foot basket will stick out but can you still close the tailgate? I understand on the M101A2 trailer you will have to drive over one of the inner fenders. Would really like to buy a mule but need to store it in a trailer. Thanks for the help. Also maybe drive it in and have the foot...

I just wanted to be able to see out the passenger mirror. Mark

As long as the temp outside is 65 or above she starts with no issue it's below that temp I need to glow plugs. Drove the truck today without issue as the temp was 80. Mark

It should Never be shifting at 60mph. Hate to see the RPMs in 2nd at that speed. Mine shifts fast from 2nd to 3rd at a very low speed. Mark

I have a light bar on my M998 and it virtually blocked the passenger side stock mirror so I installed mirrors on the X-doors with the 3D printed mounting plate on the upper hinges. Thank you Midwest Military Equipment and I give this part a 5 star rating. I expect a fruit cake this X-Mas for all...

LOL understood I will snap a pic of what is in there. It came off the same running truck that the PCB bax came from. Mark

I just used the pic I found for reference as mine is a older unit and I tried another used one I had same issue. Mark

A much better price can be had on the HMMWV H1 and H2 brake pads by ordering pads for the 1986-1988 AMC Jeep Eagle. The units I got were Wagner MX203 at around 20 bucks shipped. Not bad for a premium semi metallic pad. Mark

Nice project. I got my new 4 man replacement top right from Breton industries at as really good price. As some of the very knowledgeable people above stated 65mph is pushing the three speed HMMWV and 70mph is lighting an unknown length of fuse. I live mostly at right around 60mph on the...

Thanks for the replies guys. I worded my post poorly and put in the wrong part number. Let's start again. The engine harness that is now in the truck is part number 12339350 (See pic) New glow plugs Part number 2920011883863 I have a yellow stripe glow plug sensor in the intake manifold...

Still can't easily start the truck and finally figured out the glow plugs are not getting power. Have two spare take out boxes and no power to the plugs. New harness NEW!!! HMMWV engine harness P/N: --------. New plugs. New batteries. Shows no voltage at the plugs. Wait light comes on for...

Still chasing down hard starting issue. Installed a new engine harness NEW!!! HMMWV engine Harness P/N: 12339350 and there is an extra wire #54C. Only info I can find is from a flyback diode to ground. Old harness did not have this. Any help ? Thanks, Mark

I have thought the fuel pump may have issues and I have ordered a new fuel pump as well as an inline pressure gauge and new fuel line hose. Only checked the drain to see if the system is holding pressure. Thank you for the reply. Mark

Been having big problems for a while now with my truck. Old GP controller failed. List of new parts. New controller, New glow plugs, New coolant temp sensor for FI advance, New engine wiring harness, New grounding kit, New controller box GP sensor, New fuel filter, New batteries. Glow plug...

Those Swiss trailers are really nice and as I recall the brand is Stuart . You have a nice setup. Below is my setup. Mark

Very bright (1800 lumens each) 10 to 30 volts Mark

I mounted mine on the antenna mounts and run them via a switch. Also have a back up alarm on the circuit. Mark

Great info thank you very much. Mark

When we installed the new harness it had the new connector for the box. Same issue still there. Thank you for the help all good stuff. The relays under the dash are working Two of them. I will try to clean the contacts for the **** of it but have had two different known good boxes in there...