Search results

I have a 30kw on trailer with ask. It is a lot quieter. The 60kw is slightly larger not sure if it would fit in the same ask but maybe.

Call 203-378-7105 I can help you Will

Half 12 and half 24 volt. Standard Bosch style automotive relays. Panel inside should have a diagram showing what's what.

Thermal interrupt would prevent cranking. Get some new relays for your panel.

My turbo spools right up. It's hard to hear just the turbo in your vid. It should have been fully spooled and screaming though.

Great job. Everyone underestimates the truck.

If the starter solenoid is engaging but not turning over it could be due to weak batteries. Someone else I know had this issue recently.

Measure make sure you have 12 and 24 volts at the panel left lugs. Manually open the cab and jump the aux start solenoid drivers side frame rail see if it starts. Have power switch on or it will just crank. Could be a bad relay in the panel or something simple. You could also jump the starter...

You can tap off the 2 legs but will only have 2/3 of the rated capacity. 20kva is prob around 15-17kw. Converting phase is expensive. Easiest way to convert phase either way is with a device that has a 3 phase motor on one side and a single phase gen head on the other side. You would have to...

Push the button again. It inhibits the fuel solenoid. You can manually put 24v to the fuel solenoid with a clip lead.

I think the engine is governed at 2600 rpms. The truck in my pull vid has a mil reman engine that was installed not too long before the truck was sold off. It does rev a bit nicer than the other 4x4 trucks I have. The 5 Ton 290hp 3116 revs real nice. There is a noticeable difference between the...

Makes it look easy. How much weight?

If on dirt drop tire pressure to XC

To get into low range you have to keep pressing arrow down till the display shows 1 1. It takes a few extra presses sometimes. Mode just makes power 50/50 to the axles. Good luck with it.

The hand throttle should be tight enough to stay where you set it. The pedals all appear to bend. I have an extra I was going to play with trying to reinforce just haven't got around to it. The A1 trucks have a sturdy electronic throttle pedal.

Are you missing the one valve or the whole manifold block? Post a pic. The parts tm has an individual breakdown of the manifold if you just need one small part.

I still have a set here. Just the keypad brings 4-600 on the bay

I bet tactical truck bought from GL at New Castle. Delaware has no sales tax so no tax charged on anything purchased there. Regardless of what state you live in.

Mine does that too. The trans ecu pinout is available online. I'm sure you could rewire it to function how you like.

Not feeling the love here