Search results

If you have money to blow there is ways to make 60 hz power. Or any non rotating things should work (resistive heat lights etc. No motors) Sent from my SM-S908U using Tapatalk

The power connector is a GPC connector its for aircraft. I bet you a dollar its 28vdc and or 3 phase 120v 400 hz Sent from my SM-S908U using Tapatalk

Are you slamming the load or slowly adding Sent from my SM-S908U using Tapatalk

Glad to hear you got it running Sent from my SM-S908U using Tapatalk

Tell that to Amazon. I ordered a large resistor (think foot long glass tube) and they thought it was acceptable to mail it in a bag. Twice. They did replace it and the 3rd was intact. And for some reason they didn't allow the review. "The third item worked great, the first 2 however succumbed to...

Have you tried digikey? Sent from my SM-S908U using Tapatalk

if you cant find an exact match, get something higher rated. that being said I usually go to digikey for parts like this. here is an example. You also need to make sure they are pointed the right way. I dont have the TM in front of me at the moment so I cant say what the ratings were...

Keep it simple, unless complex is really really cool Sent from my SM-S908U using Tapatalk

Depends how automatic you want to go and your skill level Sent from my SM-S908U using Tapatalk

Depends on how much you really want to spend. voltage and current monitoring, voltage control and throttle control.

Run it hard and hot. That will help clear that carbon Sent from my SM-S908U using Tapatalk

Higher rated diodes are ok to use. They need disconnected to test as the reversed bias ones will not give you usable results. Sent from my SM-S908U using Tapatalk

Depends on how far you wanna rig it. Avrs would need some degree of external control, but yea not something the average person would want to attempt. Sent from my SM-S908U using Tapatalk

Id be concerned about the heat. But thats just a thought Sent from my SM-S908U using Tapatalk

It isnt impossible to parallel them. But its complex. Sent from my SM-S908U using Tapatalk

I thought that was you but my brain is too far gone for the evening Sent from my SM-S908U using Tapatalk

I believe somebody here has already done the 803 to an ATS I did my 004 to a Generac ATS and I believe the N1 and N2 terminals are the normal Power detection points Sent from my SM-S908U using Tapatalk

I've had the similar situation on other equipment and ended up having to make an adapter plate Sent from my SM-S908U using Tapatalk

For the record I have a 004 and it's fully automated. I was left unsupervised and I am good with controls Sent from my SM-S908U using Tapatalk

If its like the units I've screwed with its a traditional water heater mixer with an air conditioner. So it draws about what a window shaker would when in heat pump mode Sent from my SM-S908U using Tapatalk